Cooker Hood
Created: 18/04/11
Id give this an excellent as the finish is very good, but my only reasons for a downgrade really are:
1 Not much difference in fan speeds
2 Lamps are filament bulbs not halogen
Other than that the finish is very good, its easy to fit and does the job. I have set up for full extraction, so cannot comment on the carbon filter set up :)

Thank you for voting. If your vote meets our
guidelines, it will be posted within 24 hours.
You cannot vote on the helpfulness of a review you wrote.
Your request cannot be processed at this time. Please try again later.
ventalation
Created: 16/02/10
Baumatic no longer fit the back draft flaps on the top of the fan so if you are venting into a chimney stack the air blows back through fan and filters when extractor not in use. ok if venting to outside house wall where you can fit grill on ducting pipe but fitting instructions still show both types of venting

Thank you for voting. If your vote meets our
guidelines, it will be posted within 24 hours.
You cannot vote on the helpfulness of a review you wrote.
Your request cannot be processed at this time. Please try again later.
Kitchen Hood
Created: 20/11/10
cracking bargain, three speeds with twin light.
The baumatic is stainless steel which can easil be cleaned. Easy to fit.

Thank you for voting. If your vote meets our
guidelines, it will be posted within 24 hours.
You cannot vote on the helpfulness of a review you wrote.
Your request cannot be processed at this time. Please try again later.
Baumatic F60.20 SS Cooker Hood
Created: 08/03/11
This cooker hood extractor is a powerful piece of kit and saying that since fitting ours we have only used it on the lowest setting. Because it is powerful it is quite noisey but it certainly does it's job. It is fairly straight forward to fit the instructions say it takes 2 people to fit it, but I did it on my own using blocks to sit it on before drilling, and it looks the part when it's finished. There is plenty of illumination from the twin internal lights. The fliters are easy to remove (we haven't had to clean them yet) The fixing height varies depending on if it is over a gas or electric hob, I googled it and came up with a hieght of 720mm to 750mm above worktop.

Thank you for voting. If your vote meets our
guidelines, it will be posted within 24 hours.
You cannot vote on the helpfulness of a review you wrote.
Your request cannot be processed at this time. Please try again later.
Baumatic F60.2SS Kitchen extractor hood
Created: 28/08/10
fan is very noisy but effective - but it looks well and is easy to fit but you do need a ducting kit - which I already had as I was replacing an older version of the same hood.The `non return flaps` on the hood were missing but I used the ones off the old hood and wrote to Baumatic (included a photo of the component which had parts missing) but recieved no reply

Thank you for voting. If your vote meets our
guidelines, it will be posted within 24 hours.
You cannot vote on the helpfulness of a review you wrote.
Your request cannot be processed at this time. Please try again later.