Attaching The HairDo Synthetic Salon Clip-In hair

Views 2 Likes Comments Comment
Like if this guide is helpful

How to Open the Clips:

With the clips side of the piece facing you, put both thumbs on each side of the clip and the index fingers at the front sides. Snap the clip open by applying pressure toward yourself with your index fingers. Similarly, close the clip by applying pressure away from yourself with rhe thumbs.

  • SEPARATE THE HAIR AND CLIP UP

Using a tail comb or your index fingers, practice parting the hair horizontally from one side of the head to the other. Starting about an inch above the ears, part the hair around the back of the head just below the crown and to the other ear. Then, lift up all the hair above the part and clip it out of the way using the enclosed duck-bill clip(s).

  • PIN UP THE HAIR THAT IS BELOW THE PART

Take the remaining hair and in large pin curls so that its to the head as possible.

  • PLACEMENT OF FIRST CLIP

Open all the clips on the piece. The top middle clip should be attched first by placing it at the middle of the back of the head just below the part so that the top of the weft is even with the part when attached. Moving the clip downward, catch your hair in the clip and snap it shut.

  • PLACEMENT OF THE SECOND CLIP

The lift clip is next. Holding the middle clip in place with your right hand, use your left hand to move the left edge of the weft as far as it will go around your head. As above, place the clip on your hair just below the part, and moving the clip downward, catch your hair in the clip and snap it shut.

  • PLACEMENT OF THE THIRD CLIP

To attach the right clip, hold the middle clip in place with your left hand, and use your right hand to move the right edge of the weft as far as it will go around your head. As in the previous two steps, place the clip on your hair just below the part, and moving the clip downward, catch your hair in the clip and snap it shut.

  • CHECK FOR GAPS

Now that the three top clips are attached, run your fingers along the top weft to make sure it lies flat against your head along the entire width. If there are any gaps, correct this by snapping the clip open, lifting it off your hair and repositioning it so that the weft lies flat.

  • PLACEMENT OF THE FOURTH CLIP

The bottom right clip is next. Pull the hair out of the way and place this clip by stretching the piece down to the bottom edge of the nape and slipping the clip into your hair, making sure the clip securely catches the hair at the end of the nape.The vertical stretch lace allows the piece to be pulled taut so that no gaps occur between the top and bottom of the piece.

  • PLACEMENT OF THE FIFTH CLIP

The bottom left clip is next. As in the previous step, attach the left bottom clip making sure the clip securely catches the hair at the end of the nape.

  • PLACEMENT OF THE SIXTH CLIP

The right side clip is next. As in the previous step, attach the right side clip into the hair behind your ears making sure the clip securely catches your hair.

  • PLACEMENT OF THE SEVENTH CLIP

The left side clip is next. As in the previous step, attach the left side clip into the hair behind your ears making sure the clip securely catches your hair.

  • FINISHING THE LOOK

Release all the hair that was clipped out of the way in Step 1 and blend in with the HairDo™ Synthetic Salon Clip-in Hair.

 

Have something to share, create your own guide... Write a guide
Explore more guides