CLEAR / MATTE PAINT PROTECTION VINYL

Like if this guide is helpful
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page

Fitting Instructions

Always install in an enclosed, well lit area avoiding direct sunlight and wind with a temperature range of 60°F to 90°F.

Thoroughly clean the surface to be covered making sure that all polish, wax and dirt is removed. Be sure to remove any particles that you don’t want trapped underneath the vinyl Cut the vinyl to size, if necessary, cut a paper template first .On large surfaces, a very mildly soapy solution (add a few drops of Johnsons Baby Shampoo only) can be applied, a test is always advisable. Wet the outer side of the vinyl with a spray bottle, remove the backing paper and wet the adhesive side as well. Never allow a “dry” adhesive side to touch another. Always clean and wet your fingers before touching the adhesive side of the film as fingerprints will leave permanent and visible marks.
Ensure there is sufficient water between the surfaces to manoeuvre the vinyl into position.
Once in position, squeegee the water from the centre towards the edges, overlapping the squeegee strokes and making sure you remove all the air bubbles.
If any section needs repositioning, lift and re-wet. You can reposition as many times as is needed as long as the adhesive remains wet.
Once the vinyl is in place make sure all edges are firmly pressed down and heated with a heat gun, if any edges will not stick nicely, allow half an hour and re-fix down with the aid of a heatgun and if necessary by applying a fine spray of rubbing alcohol to the adhesive area.

Application Hints

Avoid leaving bubbles under the film, ensure that overlapping strokes are used in application.
Pay close attention to curvy or contoured areas where bubbles tend to form most often.
Gentle stretching may be necessary on contoured areas, avoid excessive stretching.
When dirt or air is found under the material or when repositioning is necessary, the film may be pulled back up gently. Be sure to spray plenty of soap solution underneath the area while slowly pulling up the material.
On some glossy vinyl's, a protective film requires removal after installation.
Although this product has been extensively tested to be safe and effective on all surfaces, you are advised to test a small piece of this vinyl on a discreet area before commencing the application.

ATTENTION CUSTOMER

WE AT UNION-MART-UK THANK YOU FOR YOUR BUSINESS AND HOPE THAT YOU ENJOY YOUR PURCHASE. YOU MAY FIND THAT YOUR ITEM HAS SOME AIR BUBBLES/WAVES WHEN UNWRAPPED. THIS IS BECAUSE IN VARYING WEATHER CONDITIONS THE VINYL AND BACKING CONTRACT AND EXPAND AT DIFFERENT RATES.

THIS IS UNFORTUNATELY UNAVOIDABLE AND CAN OCCUR DURING TRANSIT REGARDLESS OF HOW IT IS PACKED, ROLLED IN A TUBE OR LAYERED IN A BOX - YOUR ITEM IS NOT DAMAGED.

THESE BUBBLES/WAVES CAN BE SMOOTHED OUT ON THE BACKING BY USING A SQUEEGEE OR APPLIED AS SUCH. THE ADHESION OF THE PRODUCT WILL BE UNAFFECTED. REMEMBER TO USE A HEAT SOURCE DURING APPLICATION FOR BEST RESULTS; IT HELPS TO ACTIVATE THE ADHESIVE. SEE INSTRUCTIONS FOR FURTHER FITTING TIPS.

PROBLEM WITH YOUR ORDER?

In the unlikely event that there is a problem with your order, please contact us via the eBay messaging system, rather than leaving negative feedback or opening a case. We always endeavour to resolve any problems or answer any queries you may have.


THANK YOU 
UNION MART
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page
Have something to share, create your own guide... Write a guide
Explore more guides