Simple guide for the first time COLCO LAMA FLYER.
The 4 switches on the bottom left of the transmitter (TX) should be positioned (left to right) down-up-down-up.
make sure all your batteries are fully charged.
-Make sure the battery is diconnected and the power is off on the transmitter
-Plug the battery into the helicopter
-Place the helicopter on a stable surface so the gyro can engage.
-Extend the transmitter aerial fully
-Turn on the transmitter
there are 2 types of receiver.light yellow and dark yellow.
LIGHT YELLOW RX LIGHTS
-start up at fast flashing red (initialistion)
-go to slow flashing red (gyro engaged)
-solid green (ready to fly, only goes green once the tx is turned on)
DARK YELLOW RX LIGHTS
-Flashing red (initialisation)
-Solid red (gyro engaged)
-solid green (ready to fly, only goes green once the tx turned on)
IF YOU CRASH
-Turn the transmitter off and unplug the battery
if you do not do this your blades may keep turning, burn out motors and certainly damage the blades more than you already have done.
CONTROLS POSITION AT STARTUP
-Left stick full down.
-left vertical trim full down.
BATTERY CHARGE TIME
about 90 minutes
All lights should go green on the blue unit (balancer)
the charger charges at .8 A
the battery is 1000 Mah
Approx 8 to 12 minutes depending on how agressively you fly
are written on the bottom of the Blue/Orange balancer unit
MORE TO COME