Citroen Evasion Air Con Compressor Fitting Guide A/C AC

Views 1 Like Comments Comment
Like if this guide is helpful

Buy Citroen Evasion A/C Compressors from £175.00  in our Ebay store. We have a vast selection of Citroen Evasion Air Con Compressors, new, reconditioned and remanufactured.

Below is a fitting guide for your convenience - Please give us a positive vote if it proves useful.

When a failed Citroen Evasion air conditioning compressor is replaced by a new Citroen Evasion a/c compressor, it is so important to have the lubricant distributed evenly across the Citroen Evasion air conditioning compressor and the Citroen Evasion a/c system before engaging the system for the first time.

If this is overlooked and the Citroen Evasion air con compressor is engaged immediately after is has been charged with refrigerant, it may happen that all the oil in the Citroen Evasion a/c compressor will be pushed out all at once while there is no oil yet to enter the Citroen Evasion air conditioning compressor on the other side. This is caused by the fact that it takes some time for the oil to spread across the system and mix with the refrigerant. Eventually the Citroen Evasion ac compressor may be damaged because of a lack of lubrication during the first few minutes of operation.

This will of course be more problematic after the system has been flushed, this will mainly be the case after the Citroen Evasion air con compressor has suffered a catastrophic failure with metal particles from the Citroen Evasion a/c compressor being spread across the entire system.

A rule of thumb guide when installing a new Citroen Evasion air con compressor is to manually turn the Citroen Evasion a/c compressor pulley
to make sure that the oil is distributed through the Citroen Evasion air con compressor evenly. Experienced engineers will
normally turn the Citroen Evasion ac compressor 10—15 times to ensure that oil has been pushed around the system.

There is still more to do to prepare the Citroen Evasion air con compressor, knowing and following the procedure will be of great importance if a newly installed Citroen Evasion air conditioning compressor should fail after a short period of time and within its warranty period. There is no bigger disappointment than having a warranty claim denied because something as simple as the following procedure has been overlooked.

Generally new Citroen Evasion a/c compressors are supplied charged with oil, but it is always recommended that you check this by draining the new Citroen Evasion air con compressor to check the amount of oil in the Citroen Evasion air conditioning compressor.

Then once you have removed the old Citroen Evasion a/c compressor you should do the same again, empty the old Citroen Evasion ac compressor of oil to see how much oil was in it and then fill the new Citroen Evasion air con compressor with the same amount this is to avoid over charging the system with oil.

After this has been done and the Citroen Evasion a/c compressor has been fitted, you do not engage the Citroen Evasion air con compressor with the engine running until the following steps have been followed.

1, Open all air louvers at the dash board, 2, Start the engine and let it stabilise at idle speed 3, Set the
blower at maximum speed, 4, Engage the Citroen Evasion a/c system and operate it continuously for 2 minutes at below
1500 rpm.

After the two minutes the Citroen Evasion air con compressor oil will have distributed evenly throughout the Citroen Evasion a/c system.

For all of your Citroen Evasion Air Con Compressor Pumps and other Evasion Air Conditioning parts visit our Ebay Shop

Please click 'Yes' below so this guide can help others.

Have something to share, create your own guide... Write a guide
Explore more guides