Daewoo Radiator Fitting Guide - Save on Garage Fees!

Views 8 Likes Comments Comment
Like if this guide is helpful

There are several things to remember when removing and refitting a Daewoo car radiator.

The first is the fragility of the unit. Most modern Daewoo radiators are made from an aluminium centre core capped on both ends with plastic tanks.

Unlike the older copper and brass Daewoo radiators they are not easily repaired and even the slightest nick in the aluminium core can render the Daewoo radiator useless.

The Daewoo radiator plastic end tanks are also fairly fragile and great care should be taken to not knock the plastic locating pins.

NEVER remove a Daewoo radiator cap from a Daewoo car radiator expansion tank or Daewoo radiator whilst the engine coolant is still hot. Great pressure can build up in some Daewoo radiator systems and the fitter must be sure that the engine and it's cooling system have had sufficent time to cool.

If your Daewoo radiator is of copper and brass construction be careful  not over tighten any threaded fittings such as the hole for the Daewoo radiator fan switch. The fittings are only soft soldered into the Daewoo radiator tank and can easily be broken if over tightened.

Care should also be taken when removing and refitting the Daewoo radiator hoses on to the Daewoo radiator pipes, again these fiitings are soft soldered and can form leaks if excessive force is used.

If your Daewoo radiator has an inbuilt oil cooler with threaded fittings for the pipes ensure they are not cross threaded when attaching.

Always, always, always replace the anti freeze solution when refilling the Daewoo radiator. The antifreeze also acts as engine coolant as it has a higher boiling temperature than water. Aways use the manufacturers recommended soultion and observe the correct ratio of water to anti freeze.

When you are confident that the Daewoo radiator is fitted correctly and all pipes are sufficently tightened you will need to run the engine until it gets warm enough for the thermostat to open and circulate the water through the entire system. It is ESSENTIAL to remove any trapped are from the Daewoo radiator cooling system as air expands greatly and can blow a Daewoo radiator from the pressure build up.

It is advisable to set the heater temperature control to HOT as this will allow water to circulate through the unit. Do not switch the fan on as this will only slow the process of heating the system.

If you are in any doubt about removing or refitting a Daewoo radiator you should leave it to your local garage or car radiator specialist.

If this guide was of any use to you please give us a positive vote!

You can buy all of your Citroen radiators and air conditioning parts in our eBay Shop

Have something to share, create your own guide... Write a guide
Explore more guides