Fitting Vinyl stickers

Like if this guide is helpful

Applying Vinyl Lettering & Graphics
       Before applying your Vinyl Lettering or Graphics thoroughly clean and dry the area first
________________________________________
Position the lettering in the desired place
and secure temporarily with a high tack
masking tape as shown opposite     

________________________________________
Apply masking tape along the top edge of
the lettering or graphics and the surface its
being applied to thus creating a hinge    

________________________________________
When dealing with large letters or long
lengths of lettering cut in between each
individual letter first as shown opposite    

________________________________________
Lift up the vinyl on its hinge and completely
remove the backing paper as shown opposite and put this to one side for later     

________________________________________
Slowly and carefully allow your vinyl to
come back down and make contact with
the surface its being applied to    

________________________________________
Using a squeegee with a firm pressure
start at the top centre, work downwards
and outwards when applying the lettering
to the surface    

________________________________________
Start removing the application tape at one
corner and slowly draw it back on itself
at 180 degrees as shown opposite     

________________________________________
To ensure the vinyl is firmly attached cover it with the backing paper, the shinny side facing
the vinyl, and squeegee again.  Any air bubbles pop them with a pin and squeegee again.

Have something to share, create your own guide... Write a guide
Explore more guides