How to Apply Edging Tape

Like if this guide is helpful
Using pre-glued edging tape to cover raw edges such as MDF, Plywood, Blockboard, Chipboard and other panel edges is quick, clean and easy.
Follow these simple steps to apply your edging tape for great results - 
 
  1. Cut the edging tape to the length required, leave a little extra at each end. Place the edging so that it overhangs evenly on both sides of the board. If possible clamp the board in an upright position so that the iron can be used horizontally.
  2. Set the iron to a Medium heat setting. Move it slowly along the edging from one end to the other, apply some downward force as you move along. As the adhesive is melting you will see a small bead expand out from the underside of the edging tape.
  3. To ensure that the edging tape fully adheres to the board use a small block of wood and move it along the edging from one end to the other while still hot. Continue to apply pressure until the adhesive has cooled and hardened.
  4. Remove the excess edging tape from each end of the board with a  Stanley  blade. Trim the overhanging edge with an Edge Trimming Tool or Stanley blade.
  5. Remove sharp edges by lightly sanding with 120-grit sand paper.
  6. If a real wood Veneer Edging has been used then apply the finish of your choice (oil, stain, varnish etc). Melamine edging does not require any finishing.​
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page
Have something to share, create your own guide... Write a guide
Explore more guides