How to hang wallpaper

Views 5 Likes Comments Comment
Like if this guide is helpful

Introduction
Hanging your own wallpaper can be an experience you'll never forget. These steps are for drywall or plaster walls that are primed and painted and don't yet have wallpaper on them.
Instructions
Difficulty: Moderately challenging
Preparing the Walls
Steps
1 Step OneLook for cracks, nail holes and loose paint or plaster on the walls. Fix them first

2 Step Two Be sure that the walls are clean and dry and that every surface is either painted or primed. You don't want to apply paste to a surface that will just absorb it - the paper might not stick.

3 Step Three Remove all the electrical plates after you've washed the walls.

4 Step Four Plan to start papering in a place that is inconspicuous, and remember that your starting point will also be your ending point. (Corners and the areas behind opening doors are good places to start.)

5 Step Five Beginning at a doorway or corner, measure a distance that's an inch or two shorter than the width of your paper. Make a mark at this distance - be sure to make the mark as light as possible so that it won't show through the paper's background.

6 Step Six Using a carpenter's level and a pencil, draw a vertical line from the floor to the ceiling through this mark. If you start at a corner, be sure to use the level, not the corner, as your guide. You will align your paper to this line - again, be sure to make the mark as light as possible.

Hanging the Paper
Steps
1 Step OneWith a utility knife, cut a length of paper that's about 4 inches longer than the wall, from ceiling to baseboard. (With a large repeating pattern, you might have to cut the strips longer to make sure the pattern matches up from piece to piece.)

2 Step Two Apply paste to the paper Or, if using prepasted wallpaper, follow the manufacturer's instructions. (Most professional installers apply paste even to prepasted wallpapers, but be aware that this voids some manufacturers' warranties.)

3 Step Three Start at the ceiling, aligning the paper with the plumb line you drew on the wall. Roughly 2 extra inches should flop against the ceiling, and 2 more inches should flop below the top of the skirting board

4 Step four  using a smoothing brush or a plastic smoother (which looks like a wide spatula without the handle). Remove wrinkles by pulling a section of the paper away from the wall until you reach the wrinkle. Smooth out the paper as you lay it back against the wall.

5 Step five smooth from the middle out, applying enough pressure to push out the bubbles but not pressing so hard that you stretch or tear the paper. If you have an air bubble that just won't budge, poke it with a pin and press down on the paper before the adhesive dries. 

6 Step Six Trim the paper. Using a wide putty knife, press the paper against the ceiling, skirting corner and trim it with a sharp razor blade. (The putty knife provides a straight edge to guide the blade.)

7 Step Seven Continue with the next piece, aligning it with the one you just laid down. If a pattern just won't line up between two strips, match it at the most obvious spot - eye level.

8 Step Eight Roll each seam with a seam roller, but don't press so hard that you squeeze out all the adhesive. Go back 10 or 15 minutes later and roll each seam again.

9 Step NineWhen you reach the end - the place where you started - you'll want to create a clean final seam. Lap the final strip of paper over the first strip and trim both simultaneously.

10 Step Ten Be sure to wipe any excess adhesive off the paper, ceiling, baseboards and adjoining strips. Use a wet sponge, following with a dry rag.

Have something to share? Create your own guide... Write a guide
Explore more guides