SAAB 900 Air Con Compressor Fitting Guide AC A/C aircon

procold_uk
By Published by
. Views . Comments . 3 Votes

Buy SAAB 900 A/C Compressors from £175.00  in our Ebay store. We have a vast selection of SAAB 900 Air Con Compressors, new, reconditioned and remanufactured.

Below is a fitting guide for your convenience - Please give us a positive vote if it proves useful.


When a failed SAAB 900 air conditioning compressor is replaced by a new a/c compressor, it is so important to have the lubricant distributed evenly across the SAAB 900 air conditioning compressor and the SAAB 900 a/c system before engaging the system for the first time.

If this is overlooked and the SAAB 900 air con compressor is engaged immediately after is has been charged with
refrigerant, it may happen that all the oil in the SAAB 900 a/c compressor will be pushed out all at once while there
is no oil yet to enter the SAAB 900 air conditioning compressor on the other side. This is caused by the fact that it takes some time for the oil to spread across the system and mix with the refrigerant. Eventually the SAAB 900 ac compressor
may be damaged because of a lack of lubrication during the first few minutes of operation.


This will of course be more problematic after the system has been flushed, this will mainly be the
case after the SAAB 900 air con compressor has suffered a catastrophic failure with metal particles from the SAAB 900 a/c compressor being spread across the entire system.


A rule of thumb guide when installing a new SAAB 900 air con compressor is to manually turn the a/c compressor pulley
to make sure that the oil is distributed through the SAAB 900 air con compressor evenly. Experienced engineers will
normally turn the SAAB 900 ac compressor 10—15 times to ensure that oil has been pushed around the system.


There is still more to do to prepare the SAAB 900 air con compressor, knowing and following the procedure will be of
great importance if a newly installed SAAB 900 air conditioning compressor should fail after a short period of time and within its warranty period. There is no bigger disappointment than having a warranty claim denied because
something as simple as the following procedure has been overlooked.


Generally new SAAB 900 a/c compressors are supplied charged with oil, but it is always recommended that you
check this by draining the new SAAB 900 air con compressor to check the amount of oil in the SAAB 900 air conditioning compressor.


Then once you have removed the old SAAB 900 a/c compressor you should do the same again, empty the old SAAB 900 ac compressor of oil to see how much oil was in it and then fill the new SAAB 900 air con compressor with the same amount this is to avoid over charging the system with oil.


After this has been done and the SAAB 900 a/c compressor has been fitted, you do not engage the SAAB 900 air con compressor with the engine running until the following steps have been followed.


1, Open all air louvers at the dash board, 2, Start the engine and let it stabilise at idle speed 3, Set the
blower at maximum speed, 4, Engage the SAAB 900 a/c system and operate it continuously for 2 minutes at below
1500 rpm.


After the two minutes the SAAB 900 air con compressor oil will have distributed evenly throughout the SAAB 900 a/c system.

For all of your SAAB 900 Air Con Compressor Pumps and other SAAB Air Conditioning parts visit our Ebay Shop

Please click 'Yes' below so this guide can help others.

 
Write a guide
Explore More
Choose a template

Additional site navigation