Skoda Aircon Compressor Fitting Guide

Views 6 Likes Comments Comment
Like if this guide is helpful

When a failed Skoda air conditioning compressor is replaced by a new Skoda a/c compressor, it is so important to have the lubricantdistributed evenly across the Skoda air conditioning compressor and the a/c system before engaging the system for the first time.

If this is overlooked and the Skoda air con compressor is engaged immediately after is has been charged with
refrigerant, it may happen that all the oil in the Skoda a/c compressor will be pushed out all at once while there
is no oil yet to enter the Skoda air conditioning compressor on the other side. This is caused by the fact that it takes some time for the oil to spread across the system and mix with the refrigerant. Eventually the Skoda ac compressor
may be damaged because of a lack of lubrication during the first few minutes of operation.


This will of course be more problematic after the system has been flushed, this will mainly be the
case after the Skoda air con compressor has suffered a catastrophic failure with metal particles from the Skoda a/c compressor being spread across the entire system.


A rule of thumb guide when installing a new Skoda air con compressor is to manually turn the Skoda a/c compressor pulley to make sure that the oil is distributed through the Skoda air con compressor evenly. Experienced engineers will normally turn the Skoda ac compressor 10—15 times to ensure that oil has been pushed around the system.


There is still more to do to prepare the Skoda air con compressor, knowing and following the procedure will be of
great importance if a newly installed Skoda air conditioning compressor should fail after a short period of time and within its warranty period. There is no bigger disappointment than having a warranty claim denied because
something as simple as the following procedure has been overlooked.


Generally new Skoda a/c compressors are supplied charged with oil, but it is always recommended that you
check this by draining the new Skoda air con compressor to check the amount of oil in the Skoda air conditioning compressor.


Then once you have removed the old Skoda a/c compressor you should do the same again, empty the old Skoda ac compressor of oil to see how much oil was in it and then fill the new Skoda air con compressor with the same amount this is to avoid over charging the system with oil.


After this has been done and the Skoda a/c compressor has been fitted, you do not engage the Skoda air con compressor with the engine running until the following steps have been followed.


1, Open all air louvers at the dash board, 2, Start the engine and let it stabilise at idle speed 3, Set the
blower at maximum speed, 4, Engage the Skoda a/c system and operate it continuously for 2 minutes at below
1500 rpm.


After the two minutes the Skoda air con compressor oil will have distributed evenly throughout the Skoda a/c system.

For all of your Skoda Air Con Compressor Pumps and other Skoda Air Conditioning parts visit our Ebay Shop

Have something to share, create your own guide... Write a guide
Explore more guides