Details about AUDI A4 A6 A8 CVT MULTITRONIC ECU AUTO GEARBOX TRANSMISSION CONTROL UNIT REPAIRAUDI A4 A6 A8 CVT MULTITRONIC ECU AUTO GEARBOX TRANSMISSION CONTROL UNIT REPAIR See original listing
09 Oct, 2013 08:24:40 BST
BRISTOL, Avon, United Kingdom
MULTITRONIC GEARBOX ECU
ON THIS LISTING GEARBOX ECU TESTING ONLY COST £ 100 (INCLUDING FREE SHIPPING)
COST REPAIR ECU £150 (INCLUDING TESTING , REPAIR ,SHIPPING )
LIFETIME ULIMITED MILEAGE WARRANTY*
WE REPAIR CVT GEARBOXES ,SEE MY OTHER AUCTIONS
IF TESTING ECU DOESN'T SHOW ANY FOULT AND YOU DECIDE TO REPAIR GEARBOX WITH US .WE GIVE YOU BACK ALL THE MONEY OF THE TESTING
What you must do?
1 Visit us.We will do full diagnostics test gearbox and ECU -FREE
We Remove and install the ECU (COST £ 100 )
after fitting WE DO ADAPTATIONS CLUTCH - FREE
AT THE SAME TIME WE CAN CHANGE OIL GEARBOX - FREE
2 Remove ecu on yourself send to as ( See pictures )
we will check the ECU same day when we receive it and
We will contact you by phone to let you know the results of the test ( your decisions what to do next)on the next day we will send you tested or repair ECU back ( Express delivery )
Please safely packed ecu !!!
write information on return address , phone number and number auction
Please everything send to us
Audi gearbox center
35 Davis Street
What is repaired / replaced on your ecu ?
Common symptoms of FAULT on the controller
G182 RPM sensor implausible signal
G182 RPM sensor no signal
G195 RPM sensor implausible signal
G195 RPM sensor no signal
RPM signal from ECM implausible
Wrong transmission ratio
Solenoid N88 performance error
Solenoid N88 circuit error
No CAN communication
Monitoring clutch temperature
G194 Sender 2 pressure adaptation limit reached
G193 Sender 1 pressure signal too high
G193 Sender 1 pressure adaptation limit reached
Shift Lock Solenoid N110 shorted to ground
G194 Sender 2 implausible signal
Pressure control solenoid 1 N215 circuit malfunction
Pressure control solenoid 2 N216 circuit malfunction
Fault codes for Range sensors
CATEGORY 1 - CODES
STORED NO DISPLAY CHANGE
The fault is stored and a substitute program enables continued operation of the vehicle with some restrictions.
The fault is not indicated to the driver,since it is not critical with regard to safe operation of the vehicle. However, the vehicle will not operate properly.
CATEGORY 2 - CODES
STORED DISPLAY INVERTED
The fault is stored and a substitute program enables continued operation of the vehicle with some restrictions. The Selector Lever Position Indicator
also indicates the presence of a fault by inverting the display. The situation is not critical for the safe operation of the vehicle, however, the vehicle will not operate properly.
CATEGORY 3 - CODES
STORED DISPLAY INVERTED AND FLASHING
The fault is stored and a substitute program enables continued operation of the vehicles with some restrictions, at least until it stops.
The Selector Lever Indicator Lever indicates the presence of a fault by flashing. This state is critical with regard to safe vehicle operation.
Therefore, driving the vehicle is not recommended.
IF YOU HAVE ANY QUESTIONS call 07791493915 ALEX