This is my (well used), and very versatile, Lurem Record Power Maxi C26 Plus Universal Woodworking machine. I have had it for a few years and has done everything I have asked of it (and more).
Briefly, the machine has built in tools for the following:
Adjustable infeed table - maximum cut 4mm with extractor nozzle and bridge guard. Rotational speed - 6300 rpm. Cutterblock dia. - 60mm. Length of infeed table - 520mm. Max. depth of cut/pass - 4mm and width of cut - 250mm. Blades brake spin-stop - 4 secs.
Table height adjustable by hand wheel and button locking. Chip discharge case. Pass limiter. Extraction nozzle. Anti-throwout pawl. Rotational speed - 6300 rpm. Table dimensions - 590mm x 260mm. Max. depth of cut/pass - 4mm. Auto feed rate 7 m/mn. Max. cutting width - 259mm. Stopping time - 4 secs
Lever adjusted saw blade. Handle locking. Adjustable, scale-graduated blade angle. Chip discharge case and nozzle. Under-table retraction guard. Aluminium section table guide. 4600 rpm rotational speed. Blade diameter - 250mm (30mm bore). Blade height max. - 90mm. Blade tilt to 0-45 degs. (cutting height - 40mm then). Blade brake spin-stop - 5 secs.
Manual shaft locking - retracting shaft. Rise control locking. End-of-cut plunger handle. Guide nozzle and guard. Rotational speeds 4300rpm and 6750rpm. Spindle length - 30mm x 92mm. Stopping time - 6 secs.
3-Jaw chuck at thicknesser/surface planer. Table movement by ball-joint mounted lever. Wood clamp. Ball joint single lever control.Vertical rise controller. Extraction nozzle. Rotational speeds - 6300rpm and 3900 rpm. 3-Jaw chuck drill-bit sizes - 1 to 13. Table dimensions - 300mm x 155mm. Travel 100mm x 100mm x 100mm (sideways/up/down). Stopping times - 4 secs (high speed) and 2 secs. (low speed).
Wood screw clamp. Drawn section carriage guide swivels to 45 degs. with stop. Table dimensions - 1080mm x 140mm. Cutting capacity in front of blade - 700mm and behind (at 40mm depth - 1250mm. Wood clamp. Table rolling on roller bearings.
This machine is supplied with all sorts of guards, blades, chuck (complete with cutting blocks) and numerous accessories, including the technical manual (will the auction winner please read it!)
The single motor is single phase 220v 50hz with a 15 amp fused isolator (machine draws 10 amps approx.). The net weight (excluding all the extra bits) - 175 kgs.
Will it fit in your workshop? The overall dimensions - 1000mm x 1800mm x 940mm, but don't forget you will need at least a metre, or more, all round to get your workpiece to the machine.
This machine can produce up to 108 dB(A)s - with the thicknesser at full tilt, so please wear ear defenders at all times and always use the guards with any blade or spinning tools.