Three ODB cable adapters plus an ELM 327 v1.4 ODB2 USB Diagnostic Lead to allow additional diagnostic options for Italian cars. These can include ENIGINE, ABS, POWER STEERING and CAN ECU's (an additional KKL VAG COM may be required to connect to specific ECUs, [depending on car model]).
Green Adaptor Lead (MultiECUScan / FiatEcuScan Adaptor 1) = Engine, ABS, Power Steering
Red Adaptor Lead (MultiECUScan / FiatEcuScan Adaptor 2) = Airbag
Yellow Adaptor Lead ( MultiECUScan / FiatEcuScan Adaptor 3) = CAN
16 Pin ODB2 USB Diagnostic Lead ELM 327 v1.4 Pin Configurations:
Green Adaptor Lead = Female pin 7 to male pins 1,7,9,12.
Red Adaptor Lead = Female pin 7 to male pin 3
Yellow Adaptor Lead = Female pin 6 to male pin 1 / Female pin 14 to male pin 9 / Female pin 7 to male pin 12 Modified EML: * Please note that this ELM 327 HAS been modified to resolve the connection problems reported on the home page of MultiECUScan / FiatECUScan "Please note that almost all ELM 327 interfaces produced in the last few months have problems accesing the CAN network.The problem can be easily fixed by simply removing one resistor from the interface. The procedure is covered in the following topic on the forum: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE).
It was also reported that the new OBDLink interfaces have the same problem." Additional Items Required:
MultiECUScan / FiatEcuScan software (free or full version). Supported Vehicles:
Please see the MultiECUScan / FiatEcuScan website for a full list of supported vehicles. Other Details:
Cables fully tested on supported model before shipping.
No responsibility can be accepted for any damage caused by the lead.
Some models may require the full version of MultiECUScan / FiatEcuScan to communicate with some ECUs.