Details about SHINDENGEN MOSFET FH012AA REGULATOR/RECT
See original listing
13 Apr, 2012 20:12:58 BST
Approximately £82.99(including postage)
Joplin, Missouri, United States
|Condition:||New||Part Brand:||SHINDENGEN MOSFET|
|Make:||ALL MAKES||Manufacturer Part Number:||FH012AA|
|Model:||ALL MODELS||Surface Finish:||Factory Anodized|
SHINDENGEN MOSFET FH012AA REGULATOR/RECTIFIER
Note: later this year Shindengen will be replacing this regulator with a updated version, the new part number will be FH020AA the updated version will replace the former FH012AA. The updated version is physically the same size only minor changes have been made to the heat sink casting.
* WEATHER PROOF CONNECTORS FOR SHINDENGEN REGULATORS
*COMPLETE INSTALLATION INSTRUCTIONS WITH PICTURES
*WEATHER PROOF MAXI FUSE HOLDER
(MAXI FUSE HOLDER HAS 10GAUGE WIRE AND CAN HANDLE 55AMPS)
*30Amp MAXI FUSE (BUSS BRAND)
*3 FT OF 10 GAUGE PRIMARY WIRE RED
*3 FT OF 10 GAUGE PRIMARY WIRE BLACK
* RING TERMINALS 3M (POS. RING TERMINAL W/HEAT SHRINK END)
*( 4) 3M BUTT SPLICE CONNECTORS (W/HEAT SHRINK ENDS)
This is a UNIVERSAL regulator/rectifier kit and charging system upgrade kit.
The kit can be used to upgrade 2 wire and 3 wire stator systems on all makes and models of motorcycles.
This voltage regulator is great for replacing existing undersized or obsolete regulators.
The advanced MOSFET construction will run cooler than all OEM diode style regulators.
In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.
This regulator is capable of 50amps continuous 3 phase and 30amp single phase.
Maxi fuse protected, unlike circuit breakers which over time can get weak and be prone to nuisance tripping.
(NOTE)Not for motorcycles with 5 wire stators in which 2 of them are for brushes.
For your reference the mounting center to center is 67.5mm to 72.5mm using 6mm bolts the bolt center could be filled wider or a adapter plate could be made for other mounting applications.
Often the stator has failed and the regulator gets the blame. A stator is difficult to check completely as they often fail only when hot.
These simple checks will find some bad stators, but a stator that passes these checks may still be defective.
1. Check the resistance between the leads, this is normally under 1 or 2 ohms. If you have a 3 phase stator, the resistance between each of the 3 lead combination's (AB,AC,BC) should be equal. If you see higher resistance, or unequal resistances, the stator is bad.
2. Check the resistance to ground, it should be well over 10 Meg ohm.
Battery condition is important. No regulator can make up for a bad or weak battery.
If in doubt charge your battery and have it load tested, or simply replace it.
ALWAYS START WITH A FULLY CHARGED BATTERY
I also sell this with the connectors only LINK BELOW:
PLEASE NOTE PRIORITY MAIL SHIPPING TO CANADA AND ITALY HAS BEEN VERY SLOW. ALSO THE PRIORITY MAIL SMALL FLAT RATE BOX DOSE NOT TRACK OUTSIDE THE USA. I WOULD RECOMMEND CHOOSING THE EXPRESS MAIL OPTION TO THESE COUNTRIES THIS METHOD IS FASTER AND DOSE OFFER TRACKING OUTSIDE THE USA.
Sales Tax is charged to Missouri residents only, I mark a low value on all International orders
I SUPPORT STAND BEHIND EVERY ITEM I SELL THANK YOU FOR YOUR BUSINESS
Visit My eBay Store: MOTO-ELECTRIX
Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application