CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Grinders
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Grinders
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
If you are looking for a tool that will take abuse all day long, day in and day out I suspect you will need to spend 10 times as much as this on a machine made to do just that! If on the other hand you need a great machine that will handle incidental / light use, then this is probably the machine for you. It is well made, easy to assemble and works well. My only criticism would be the paint job on the main body which has a large patch where the paint has run... That is pretty minor and really, I don't care as long as it works the way I need it to. I would have given 5 stars had it not been for the paint job, whilst I say I don't care, it would not be an honest review if it did not reflect that minor detail... All in all, this is a great bit of kit which represents exceptional value for money.Read full review
Verified purchase: Yes | Condition: New
This is a toy not a tool! So weak it shouldn’t be on the market. Fails to do what it’s intended for. Grinder stops when you apply pressure as does the sanding belt. If you’re planning on working with anything harder than polystyrene this is not the machine for you!
Verified purchase: Yes | Condition: New
In general it is a good machine well made and substantial. The one fault I have found, and I can only speak as I find the motor that drive the belt lacks some power. I do quite a bit of woodwork, small stuff, mushrooms and the like on the lath. But when I offer a piece up to the belt it just slows until it is ineffective. The grinding disk is no problem. It appears that a "large" face of friction on the belt is enough to slow it and even stop it. Well that's mt two peneth.
Verified purchase: Yes | Condition: New
Out of the box looked good. Read the blurb switched m/c on. In a fraction of a second the belt was hard over the right side bending the side guard and wrinkling the belt .The good thing is, it cut out before I could hit the stop, After about an hour of opening and adjusting I have no complaints of performance.
Verified purchase: Yes | Condition: New
I have used it so many times, it is so handy not very powerful but great for fine work
Verified purchase: Yes | Condition: New
