Introduction
This wireless shutter release has strong anti-interference function and has
16 channels for you to choose. It is extremely useful if there are several
photographers working nearby. Each photographer could choose their own
channel to trigger off the shutter release of the camera they are going to
use without triggering others’ because of overlapping signals. You also can
control more cameras with the channel switches on the transmitter and the
receiver, and extra receivers if you need.
Wirelessly Trigger Your Camera's Shutter
-With the receiver connected to your camera's remote control socket, you can
press the button on the remote control to trigger your camera's shutter
wireless !
Also Work as a Wired Remote Control
-The receiver alone can be used as a standard wired remote control, even
without the battery and transmitter.
Two-Level Shutter Button, Autofocus, Continuous Drive & Bulb Mode Supported
Too!
-The shutter button can be pressed halfway or all the way.
-You can activate autofocus, release shutter, activate continuous drive mode
or keep the shutter open for bulb photography as well.
16 Channels with Working Distance of 100 Meters!
-Strong resistance to interference.
-There are 16 channels available so that you can switch to other channels to
avoid jamming frequency.
-Maximum working distance is about 100 Meters in open area without blockage.
Energy Saving Design, Long Working Hour
-With its low voltage and energy saving design, you don't have to change the
battery often.
-With a new battery, the receiver standby time is about 1000 hours.
-With a new battery, the remote control can trigger about 20,000 times.
How to Connect
1. Switch off the camera.
2. Make sure the receiver and remote control are on the same channel (check
the little switch on them).
3. Connect the receiver to your camera's remote control socket.
4. Press the button on the receiver to turn it on (the Power LED should stay
red when it is on).
How to Use
With the shutter button on the remote control, you can do the followings:
Autofocus:
-Press it halfway to activates autofocus. (Indicated by Green LED)
Release Shutter:
-Press it all the way to release shutter and take pictures. (Indicated by
Red LED)
Continuous Drive:
1. Switch the camera to continuous drive mode.
2. Press it all the way to release shutter continuously.
Bulb Mode:
1. Switch the camera to Bulb mode.
2. Press it all the way for 3 seconds until the Red LED on the remote
control goes off.
3. The receiver is in bulb mode now. (Indicated by Red LED on the receiver)
4. Press the button again to close the shutter.
Avoid Camera Vibration=Sharper Pictures!
-Since you can trigger the shutter without touching the camera body, it can
avoid camera vibration, thus resulting in sharper pictures
Specifications
Suitable For
CANON Powershot G10
CANON EOS 1000D(Rebel Xs)
CANON EOS 450D(Rebel Xsi)
CANON EOS 400D(Rebel Xti)
CANON EOS 350D(Rebel Xt)
CANON EOS 300D
CANON EOS 300
CANON EOS 300V
CANON EOS 50E
CANON EOS 50
CANON EOS 33
CANON EOS 30
Pentax K10D/K110D/K100D/K20D/K200D/KM/Cs205 Remote Switch Shutter
Pentax *ist D/DS/DS2/DL/DL2/K10 Remote Switch Shutter
Pentax MZ-6, MZ-L, ZX-L
Hasselblad H/H1/H2/H2D/H1D Remote Switch Shutter Cord
Contax 645/Nl/Nx/N/Digital/LA-50 Remote Switch Shutter
Samsung GX-20 GX-10 GX-1L GX-1S