Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Lifting Tools & Machines
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lifting Tools & Machines
Wheel clamp is a bit flimsy so I ordered a better wheel chock to be sure. Took about 20 minutes from crate to finished assembly..easy 1 man assembly The hydraulics are smooth and work better than I hoped for, the X design means it just goes straight up,not backward and forward like most lifts do. Very stable with my Fazer 1000 on board and once rear panel removed, rear wheel and swingarm removal etc is a piece of cake. Essential you tie the bike down for safety and I used a jack under the headers for additional security before tie down. You can use centre stand but you need a step to get onto lift to use centre stand. Folds up perfect to go under my garage shelving so for me takes up no room which again most lifts don't do..all in all I am well pleased.. I am 63 years young so this should save my knees and back!!!!!Read full review
Verified purchase: Yes | Condition: New
This lift is no good for Lambretta's it's to narrow but thats not to say it is any good it works perfect . I had to have lugs fitted on to accommodate the stand width of a lambretta so purchasers beware .It is of a very sturdy construction but there are a few minor issues ? it should have stops to prevent it moving around, also the ramp has to remain in position because of the wheelbase when the scooter is on the lift
Verified purchase: Yes | Condition: New
Very pleased with bench. It is ideal for my Kawasaki Z1. Only modification I have had to make is to fit some hooks so I can secure the bike with straps, just as belt and braces as not 100% convinced that the front wheel clamp would support when not using bike stand. Excellent value for money and a makes life so much easier to work on your bike. Does not have brakes on castors so I use wedges under wheels when putting bike on to prevent risk of it moving, has not been an issue.
Verified purchase: Yes | Condition: New
The main problem with this lift is if the centre stand is not available the load put on the platform extension/ramp section at the rear of the lift is too high. The hinge pins are too weak causing it to deflect and bend. A situation I was not expecting. The instructions with it are really poor .
Verified purchase: Yes | Condition: New
Very disappointed. Had to adjust all the settings to get the lift to work. This lift is extremely short in length and totally unsuitable for anything other than a small short bike. Any reasonable sized bike hangs dangerously off the end of the ramp making it completely unstable. I would not recommend this lift.
Verified purchase: Yes | Condition: New