This item is good quality as far as the materials and build are concerned. However I had a problem whereby the SES (E27) bulb did not reach the bottom terminal when screwed fully home. The glass part of the bulb was abutting the plastic of the holder at the top and this was not allowing the bulb to screw far enough in to make the contact. The bulb in question was an LED unit with a normal E27 thread. The glass at the base of this bulb was a different shape than a conventional, tapered glass bulb, preventing it from screwing far enough in to make contact. I eventually resolved the situation by cutting about 3mm of plastic from the top. of the holder socket. This allowed the bulb to screw slightly further in and make contact. I think this would have been the case with any conventional E27 holder unless the plastic skirt was flared slightly where it meets the bulb. If your bulb of choice is not the conventional shape, just make sure you are not going to encounter the problem I had. Alternatively choose a holder with a flared plastic skirt whereby the the bottom of the glass on the bulb can sit slightly inside the plastic skirt.Read full review
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Works well and useful to be able to use all types of standard bulb fittings; bayonet and screw in.
Verified purchase: Yes | Condition: New
It does the job at a good price. But be careful about P&P as there are others that offer free P&P.
Verified purchase: Yes | Condition: New
These adapters give you the chance to fit most any types of lamp bulbs in your fittings , and are cheaper than finding out too late, and then going off out to find the right lamps.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Light Fittings
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Light Fittings