Replacement PCB for a 15year old boiler which would not ignite the pilot light. Took less than 30 minutes to replace. Like for like connectors made reconnecting simple. Old PCB had an earth and neutral plug connector but replacement PCB came with ready soldered earth and neutral wires. This proved not to be an issue with the Earth wire going to boiler casing, and the neutral wire going to the neutral terminal of power terminal block. If I had any criticism, it would be that the neutral wire is too short and hinders the re assembly of the boilers lower control panel. This was a reconditioned PCB but looked aesthetically like a new unit. Switched boiler back on after fitting replacement PCB and the boiler fired up first time.
Verified purchase: Yes | Condition: Pre-owned
I fitted it in less than an hour. All of the existing connectors just slid into place with no problems at all. The neutral lead was in a different place to my old board but it was obvious where it needed to be fitted to. Turned the power back on and away everything went. Marvellous! Expert quoted me £260 to do the job. It cost me £69 and an hour of my time. Try them, excellent quality gear.
Verified purchase: Yes | Condition: New
took time locating and memorising which sockets went where recommend draw a simple diagram with wire colour and number of pins in plugs, It was then a simple job to install and all worked perfectly when switched back on. Well pleased
Verified purchase: Yes | Condition: Pre-owned
Magic worked a treat,very easy to fit
Verified purchase: Yes | Condition: Pre-owned
Great condition and well worth it .
Verified purchase: Yes | Condition: Pre-owned
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Standard Water Heaters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Standard Water Heaters