GUTTER GUARD MESH NO BLOCKED LEAVES GUTTERS GUTTERING 16cm Height 10M PACK NEW
27 Jul, 2016
Good product but needs securing. I used cable ties.
I have "Square Guttering", which isn't square, but that's what it's called. It's 112mm wide with the vertical side only about 15mm tall. The Gutter Guard Mesh was a bit awkward to install as it kept springing out of my model of guttering. There is no way this would stay there in any serious wind. I solved this by putting a cable tie through the mesh, two holes up on each side, and then going around the guttering underneath. I used a tie every 500mm and so far it's not moved at all. I used colour matching cable ties and the difference to the appearance it almost impossible to notice. (Don't pull the ties too tight or you will crush/distort the guttering!)
So far it's doing it's job perfectly.
One point: Due to the width of the mesh and the width of the gutter, the product is designed to bend upwards. The height of the bend, depending on the clearance between the gutter and the roof tiles, can clash with the roof tiles, but the mesh is flexible and bends around the tiles nicely. This could hamper installation. I did my first installation on the barge board on the ground so it was easy to do. I've got another gutter to treat "in situ" which might be a bit more challenging.
1 of 1 found this helpful
VAPONA FLY KILLER WINDOW STICKERS PACK OF 4 ORIGINAL SUN FLOWER
31 Jul, 2019
Works well for the flies that pitch in and use the windows.
Put these up and the next day there were a load of dead flies in the window sill and on the nearby floor. Markedly noticeable reduced number of flies on following days.
4500psi Folding Stirrup Charger PCP Pump Air Gun Rifle Airrifle Gas Filter Gauge
15 Jan, 2020
Works well so far.
Pump arrived well packed and on time. Assembly was easy, just needed the handle screwing on; it came with a set of tools, replacement seals, and lubrication. The instructions for assembly and servicing are not great but you can get the idea of what you need to do and when.
It came with an 8mm quick release air connector screwed on to a 10mm x 1 threaded connector. The fill adapter for my rifle has an 1/8" BSP thread so I had to make a Barrel Nut, 10mm x1 thread at one end, 1/8" BSP thread at the other, but once done the pump works well.