 |
Ordered this for a job fixing a picture rail up inside a church bell tower! Needed something to anchor the screws that would withstand the vibrations of the bells and was recommended this product for the task. My first mistake was to drop the tube which cracked the nozzle. My second mistake was to fix the break with gaffer tape. The first hole filled fine, the twin-bag system worked and the resin set within minutes. Then it all went wrong; the tape didn't hold and the stuff squeezed out and went everywhere. I ended up with it all over my hands, and being up in the bell tower of a church had no way to clean them. As I didn't have my glasses i hadn't (stupidly) read the warnings and health & safety guide.I gave up after the third hole as the two liquids weren't mixing and I was in a right mess. So, my advice is; This is a great product but use it VERY carefully, don't crack the nozzle and be very aware of the hazardous nature of the resin! Dispose of it carefully. And don't get it on your hands. (Grass from the cemetery proved useful in getting the worst of it off, then I drove home to wash my hands, almost gluing myself to the steering wheel in the process) Had to finish the job using wall plugs and wooden pegs to anchor them, but would definitely use this resin again, having learned a valuable lesson.Read full review
Verified purchase: Yes | Condition: New
I used this chemical anchor set to help secure a set of gymnastic rings with expansion bolts to a concrete ceiling. They did the job perfectly and am very pleased with the result. Make sure you scrape away any protruding excess as it dries rock hard very quickly. Only down side is you only set a single mixing nozzle which becomes useless after a single use. Aside from that the resin is great stuff.
Verified purchase: Yes | Condition: New
Have tried the leading more expensive competitor for two-part injection resin but found you wasted a quarter of the tube before a properly mixed product issued from the end of the nozzle. Anchorset mixes almost immediately with little wastage, and you can remove the mixing nozzle and re-stopper the tube for use later. Just wish they supplied a spare mixing tube as spares have to be bought separately. The mixed resin sets to a tough hard grainy finish in about ten minutes which can be overpainted. I found the other make set with a greasy finish which was difficult to paint. I much regret (December 2016) that Toolstation no longer stock Anchorset and I have to order it on-line.
Verified purchase: Yes | Condition: New
Brilliant stuff, anchored a dozen stainless threaded rods into concrete and held perfectly, really strong stuff.
Verified purchase: Yes | Condition: New
Superb product. Used to fix rebar to concrete floor prior to adding a wall. Only issue is it goes off very quickly. Had to remove mixing spout as it was solid after 5 minutes, and had to handmix the rest.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Adhesive Tapes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Adhesive Tapes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
