Using a roll of some fresh copper braid and a clean, well tinned soldering iron with a decently high heat capacity, this solder sucker will remove excess solder from around any pad where you wish to remove a component from a printed circuit board and leave the pad ready for a replacement component. It is important that you do not allow cold solder to build up inside the barrel, so it should be emptied immediately after use.
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Soldering Guns & Irons
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Soldering Guns & Irons