CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Printers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Printers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
If you want to use these on a FlashForge Creator Pro you have to cut them down to the appropriate length. These bearings are a great upgrade and there's no play on any of the axis once they're all installed and the machine is squared off. Stepper motors still make noise but the machine is no longer as loud on 30mm/s
Verified purchase: Yes | Condition: New
Product: Genuine Igus® Drylin RJ4JP-01-08 8mm Linear Bearing x 7 Replace LM8UU 3D Reprap Printer: ANET A8 Like many other 3D printers, my x-axis was very noisy. Also, sliding the carriage across manually I could feel numerous spots that required more pressure. Genuine Igus® bearings I found on the internet were too expensive for my low end printer until I found this store in Great Britain. The bearing run smoothly and quietly. I was also surprised that the shipping time was just a few days. Much shorter than from China. These bearings run very smoothly and quietly.
Verified purchase: Yes | Condition: New
Bought these to replace the stock bearings in my Anet A8. Should of been the first thing I did as these bearings are so quite. Great gliding instead of grinding ball bearings. Would recommend to anyone that has a ANET A8 and should be one if the first things you replace in the printer. Fantastic product and so glad I purchased them.
Verified purchase: Yes | Condition: New
Just using these on my wanhao i3 bed at moment .. excellent so much better than metal bearings they replaced ... move so much better .... and cheaper ... can definetly recommend these ...
Verified purchase: Yes | Condition: New
Works great, finally no rattling/grinding noise comming from standard ball bearings. Mounted on Anycubic I3 Mega on X axis using these holders: thingiverse/thing:2791727.
Verified purchase: Yes | Condition: New
