CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Lawn Mower Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lawn Mower Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
This was an excellent value for the money. I only changed the left side on my Cub Cadet as the right side was still working fine. It was an easy swap but the hydro gear units came without the input pully and fan, and also the control arm assembly and brake assembly, but these were easy to move over from the defective unit. I only had 2 issues with the swap. The control arm bolt (#40 Torx) threads in the new unit were significantly rusted and I had to flush the rust out with lots of WD40 and slowly working the bolt deeper until it would fully seat as intended. -Not this is a tapered hole and some play between it and the control arm plates is necessary when the bolt is fully tightened. My other issue was two of the wheel studs had defective threads and the lug nuts would not even start. This was resolved by carefully chasing the threads with an expensive die. The RH transmission did not have wheel stud issues, so you may not either. Note to Cub owners: These wheel studs are larger than o the Cubby. You will need to purchase 1/2"-20 lug nuts (1$ each at my local store) The existing wheels will accept the larger studs.Read full review
Verified purchase: Yes | Condition: Pre-owned
I purchased a set of these. The left ones input shaft was shoved down and broke off and when it done it it happend to bust the housing the shaft goes into inside the hydra gear. I contacted the supplier and all they said was they'd send me a new shaft. Kinda pointless with the internal peaces busted too wouldn't ya think. Just wasn't very happy with the outcome junked the mower after wasting 200 dollars on it. Won't happen again
Verified purchase: Yes
I put these in an rzt50 Cub. They fit perfect and work great. I bought 2 more for the future. I fix mowers as a hobby. These will also fit a lot of other mowers. Call them and they will tell you if they will fit your zero turn.
Verified purchase: Yes | Condition: Pre-owned
Drives work as they should. The outside cases had some chips and cases were not perfect but for the price I can over look that. The studs that others talk about are 1/2inch 20 and our not some strange metric stud. Thank you for getting my zero turn back up and running.
Verified purchase: Yes | Condition: Pre-owned
I ORDERED THE HYDRO GEAR FOR MY UNCLES MOWER . GOT IT AND INSTALLED IT , UNFORTUNITE IT DID NOT WORK . I CALLED AND TOLD THEM , THEY SENT ME ANOTHER NEW ONE , NO QUESTIONS ASKED . IF I EVER NEED ANOTHER ONE , I WILL FOR SURE BUY AGAIN FROM THEM.
Verified purchase: Yes | Condition: Pre-owned
