Had to remove a tap type washer from the inside to fit standard valve. Would not push over it. Then had to bore a hole on the top and screw fit it. Recommended it if one has the skill to adapt
Verified purchase: Yes | Condition: New
In my opinion the rubber insert located in the top of the cap is too hard, it is very difficult to fit the cap over the adjuster located on top of the radiator valve. Perhaps a softer rubber would make it easier to fit, rather than having to enlarge the existing hole pre drilled in the insert. Having said that i would still recommend this product.
Verified purchase: Yes | Condition: New
The Caps are neat and simply made with a holed rubber incert that slides over the valve stem. If the hole in the incert is too small for the valve stem as in my case. I reemed out the hole by a hand held drill bit the same size as the valve stem and then they fitted perfectly. It would be useful to purchasers if the inside of the caps was shown in sales photographs to enable them to know how the caps are fitted.
Verified purchase: Yes | Condition: New
As in the title - these finish off a tatty radiator ready for the Missus to paint!!!!
Verified purchase: Yes | Condition: New
Caps are great but you will probably have to drill a bigger hole in washer underneath in order to make it fit snugly
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Radiator Covers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Radiator Covers