Analysers & Data Acquisition Equipment

Item Type: Digital Oscilloscope. 1 Fully Assembled Digital Oscilloscope Kit. Trigger level position adjustable and with indication. With 1KHz / 3.3v square wave test signal source. /Peak-Peak/virtual values.

DSO Pro is a full function, high utility, high performance and cost-effective handheld oscilloscope for the maintenance industry and the R & D industry. With complete triggering function (single, normal, automatic), both the periodic analog signal and the aperiodic digital signal can be used freely.

Model: P6100. Output type: 100MHz. External insulation compatible with all the BNC oscilloscope. 2pcs x Oscilloscope Probe. The alligator clip is very solid. It is not easy to disconnect. Attenuation ratio: 1X&10X.

In the lab the low cost allows one scope per person rather than having to share. 2 channels. USB connected and powered. all you see is what you will get ! the pictures are of the actual item.

A new Wittig W201 100MHz switchable x1/x10 oscilloscope probe. x1/x10 switchable 100MHZ oscilloscope probe. The probes have standard BNC connectors. Typical frequency response. Cable Length. Compensation Range.

No false alarm. INSTALLATION: Twist on/off lock to insert 3 pieces 1.5V AA battery to the detector, the buzzer will make a sound “di”. After installing the battery wait at least for 3 minutes, then press the TEST/RESET button for the device to work properly.

Nobsound®——Dou​k Audio. Nobsound®——Douk Audio. Enter deep standby status. Auto wakeup when there is a signal input or press button operation. • Dedicated VFD spectrum display, Resolution 25 X 15. Speaker Frequency Divider.

Item Type: Digital Oscilloscope. 1 Fully Assembled Digital Oscilloscope Kit. Trigger level position adjustable and with indication. With 1KHz / 3.3v square wave test signal source. /Peak-Peak/virtual values.

≤24Mhz (1G depth). The analyser supports up to a 24MHz sampling rate, set through the logic software. With a sampling depth of 1G and input impedance of 100K. This analyser is ideally suited to fault finding around a circuit board, allowing you to follow logic circuit values through a circuit, making them useful for fault finding and prototyping.

Condition is New. HD Display Screen. Frequency/duty cycle, diode/continuity test. Extending battery life with automatic shutdown function.

Permanent carbon monoxide sensor. 1 x Carbon Monoxide Alarm. Test/Reset button to test the unit electronics and verifies properunit operation and reset the unit during CO alarm. Loud 85 decibel alarm with LED Flash While in the Alarm Mode.

Here I have a Gould OS300 Oscilloscope Up for bid 20 mHz dual trace 100V-220V . Item has some cosmetic marks , It is fully working , Any questions please ask

The unit turns on and shows a trace on the screen, that is as far as it has been tested for operation.

BK PRECISION OSCILLOSCOPE 2190D NIB WITH BOX UNUSED. BOX IS A BIT BASHED ON ONE SIDE.

2 x Oscilloscope Probes.

Hantek 6022BE PC Based USB Digital Oscilloscope 48MSa/s 20MHz 2CH Car Automotive. 1 x Virtual Oscilloscope. 2 x Oscilloscope Probes. Labview\VB\VC\Delphi\C Builder Second Design instance. S/W CD, probes, manual, USB cord.

Model DS212. Analog Bandwidth 1MHz. Specifications of Mini Oscilloscope Series. Horizontal sensitivity 1uS/Div~2S/Div(1-2-5 sequence step). Vertical Sensitivity 20mv/Div~10V/Div(1-2-5 sequence step). Max Sample Rate 10MSa/s.

24MHz 8 Channel Logic Analyser. 24Mhz Sample Rate. 1 x USB Logic Analyzer. 8 Channels. USB Powered.

Farnell Oscilloscope DT12-5. Condition is Used part of father in laws collection who has past away well looked after don’t know it it’s working. Dispatched with Royal Mail 2nd Class.

1 Tektronix TDS 210 Digital Oscilloscope. This oscilloscope has been used previously by myself but I have upgraded and no longer require this model. 1 Scope probe.

Item Type: Digital Oscilloscope. 1 Fully Assembled Digital Oscilloscope Kit. Trigger level position adjustable and with indication. With 1KHz / 3.3v square wave test signal source. /Peak-Peak/virtual values.

It supports 8MB storage capacity and USB charging. 1 DS212 Oscilloscope. 2-channel, 1MHz bandwidth, 1MΩ input impedance, 10MSa/s Max. sample rate. Inbuilt signal generator/10Hz—1MHz square wave (duty adjustable) or 10Hz—20KHz Sine/Square/Triangle/Sawtooth wave.

Easy access via car (M3/A316) or public transport. Cash on collection is preferred for this item. Fully working. The original focus pot died (a common problem on these) and has been replaced recently with an after market item and new shaft coupler otherwise totally original.

(4)Record capacity: 32000 points (MAX). Freon Leak Detector. Over Temperature Alarm & Upper/Lower Limits can be set. 6)Sensor: Internal NTC thermal resistor. 7)Communication interface: USB interface. 3)Temperature unit: ℃ or ℉optional.

Scopex 4S 6 Oscilloscope. 6MHz single channel oscilloscope. Two rubber feet are missing - doesn't sit level. Although this is quite small and light compared to other oscilloscopes, it is still quite big and bulky.

NI myRio National Instruments kit brand new still sealed, have multiple in stock message me for further information

Hameg HM 203 20Mhz Oscilloscope, used, but has had little use.  Features 2 DC to 20MHZ Y channels, it has X out and a built in square wave for adjusting the trimmer within the probes.  Supplied with 2 probes, both x1/x10, mains lead and workshop manual.  Ideal for servicing DVD and video machines, but has many other uses.

2 Channel. Condition is Used.

Anton Sprint Evo 1 - Flue Gas Analyser. Trusted across the UK as the flue gas analyser of choice for many gas engineers, the Anton Sprint eVo 1 builds upon the functionality of the popular Sprint V range.

Used and working.

Kane 455 Flue Gas Analyser With Printer. Calibration Expired 17/04/2019. Condition is Used. Dispatched with Royal Mail 2nd Class. Analyser is well used and bag shows signs of wear but it has been calibrated every year and is due for one now. Selling due to having upgraded. Works perfectly. Cost £700 new.

4G LTE WiFi CPE Wireless Repeater Hotspot Sim Card LAN Dual Modem Antenna. All parts of the shell oscilloscope. Electric Handheld Massager Double Head Full Body Neck Back Relax Shoulder. BNC fish clip probe.

Band Width: 100MHz. It has compact size and stable performance. Great choice for oscilloscope probe. Adjustable probe attenuation, you can choose 1X or 10X by sliding the switch. Compact size, several functions combined in one, this probe is convenient to use.

RIGOL DS1052E 2 Channel 50MHz Digital Storage Oscilloscope. Included 2 sets of probes. Usb cable. Installation cd. Power cord. Condition is Used. Dispatched with fully insured 48h Courier. Note, this Oscilloscope can be firmware hacked to 100MHz if you choose to. Please see internet for guide to turn it into a ds1102e. This model is factory default, 50 MHz. Please see pictures as part of the description and thanks for looking and please feel free to ask any questions.

Kane 77 Personal Carbon Monoxide Meter Monitor. Condition is Used.

Band Width: 100MHz. It has compact size and stable performance. Great choice for oscilloscope probe. 1 Pair of Test Probes. Adjustable probe attenuation, you can choose 1X or 10X by sliding the switch.

Relisted due to non payer and time waster. Hitachi V-650F Oscilloscope. Includes user manual. No leads included. Selling as spares or repair. Collection preferred but can post at buyers risk. Signature will be required upon delivery. Payment within 24hrs please. Sorry for this but blame the loser who didn't pay even after two weeks of waiting!