dcc chip

LaisDcc Decoder Chip 9 Wire NEM652 8 Pin + Fn2 Wire. Part No. 860021.

LaisDcc Decoder Chip 6 Wire (NEM651) + 2 Wires Stay Alive. Part No. 860012.

LaisDcc Decoder Chip 9 Wire + 2 Wires Stay Alive. Part No. 860014.

LaisDcc Decoder Chip 21 Pin (21MTC) +2 wires stay alive. Part No. 860019.

Hornby R8249 DCC Decoder Chip. All the CVs shown can be interrogated in all service modes. The Hornby Decoder supports programming on the Main. The sum of all currents to the motor and the function outputs should not exceed 500mA at normal continuous operation and cannot exceed 1 Amp.

LaisDcc Decoder Chip NEM651 6 Wire + Blue Wire Z/N Scale. 2 Function decoder with NEM651 interface standard. Part No. 860010. Decoder is supplied heat-shrink wrapped.

LaisDcc Decoder Chip NEM662 Next18. Part No. 860015. Decoder is supplied heat-shrink wrapped.

LaisDcc Decoder Chip 7 Wire 4 Function. Part No. 860011n. These are a four function decoder without a motor output.

LaisDcc 8 / 21 Pin Adaptor NEM652 Chip to 21MTC Loco. These 8-pin NEM652 to 21MTC Loco Adaptors enable you to fit an 8 Pin DCC decoder to a 21 Pin socket Locomotive.

It is interchangeable for 99%25 of locos. Bachmann 36-566 DCC Decoder Chip. This is a 4 function 0.9A decoder with 8-pin plug. Suits the vast majority of Bachmann and Hornby locos with an 8 pin DCC socket.

A lovely Hornby "Mallard" with a DCC chip installed on board. DCC on Board. As you can see from the photos this iconic loco will need a little TLC to get it back to the magnificent model that it is.

V1.3 NMRA COMPLIANT. Hornby Trains Sets. The decoder is also capable of keeping the loco running at a set speed no matter what gradients the model encounters. LOCOMOTIVE DECODER. Four On/Off function outputs.

Hornby Trains Sets. The decoder is also capable of keeping the loco running at a set speed no matter what gradients the model encounters. ONE DIGITAL DCC 'CHIP'. LOCOMOTIVE DECODER. Four On/Off function outputs.

This is a Bachmann Branchlike class 66. Condition is Used. The box is in very good condition but it has a tiny bit of shelf wear.

This in two 8 pin decoders for fitting to your DCC ready, Class 43 HST locomotive.

OO Model RailwayHornby R8249 Digital 4 function Locomotive decoder. Doubleho Model Railways.

This is an 8 pin decoder which plugs directly into the socket. Easily accessible from the main A55 with free parking outside. Reset Value: CV8 to 8. Depth: 10mm. Width: 12mm.