step down converter

Output current: Rated current is 2A, maximum 3A (if the output power more than 10W, the heat sink is needed.). Module properties: Non-isolated step-down module. Short circuit protection: Current limiting, self-recovery.

Based on MP2307 Chip. Capable of driving a peak load of 3A and a continuous load of 1.8A with excellent line and load regulation. Output current : Peak 3A, continuous 1.8 Amp. Load regulation : ± 0.5%.

This is a DC-DC step down converter module that convert 6.5V-60V to 1.25-30V, maximum current is 10A. Load capacity: up to 10A. Output: 1.25-30V (adjustable).

Output Power: natural heat 50W (less than 3.5A), enhance heat dissipation 75W. clockwise rotation, can increase the set current. When the load current reaches the set current, it enters the constant current state, and the CC constant current indicator (red) lights up.

Output Current: 5A. Resolution: 0.01V, 0.01A Short Circuit Protection: Yes. Your recognition will encourage us greatly and serve you better. Reverse Input Protection: Yes. Output Backflow Protection: No, add a diode if use for charging Size: 79 43 46mm/3.11 1.69 1.81".

Built in output short protection function. Input reverse polarity protection. How to adjust the accuracy?. Add to Favourites.

Indicator: CC indicator is Red, charging indicator is Red, charging completed the indicator is Blue. (ambient temperature more than 40?., lower power use, or add heat sink)\. CC range :0-2A (adjustable).

Output current: 10A. 1x Power Converter. Output wire color: ( )Yellow, (-)Black. Output power:120W. Input wire color : ( )Red, (-)Black. No wiring reverse short-circuit protection for this device. Thin, small size, high efficiency and easy to install.

Mini DC-DC Buck Converter. 1 x Buck Converter Module. Step Down Module. Step Down Module. 4.75V-23V input to 1V-17V output. Colour: Green, as shown in picture. Load regulation: ±0.5%. Type: Mini.

Output curret: 5A. Input: red( )black(-); Output: yellow( )black(-). 1x Power Converter. Output power:60W. Thin, small size, high efficiency and easy to install. within 24 hours.

AMS1117 LDO 5V to 3.3V Vertical Regulator Module 800mA. AMS1117 LDO 5V to 3.3V Vertical Regulator Module. Max output current: 800mA. Low dropout 5V to 3.3V Buck convertor module. Vertical mount 800mA.

5 x Mini Buck Converter Modules. Load regulation: ±0.5%. Internally Set Current Limit without a Current Sensing Resistor. Output ripple: 30mV(no-load). Transfer efficiency: 96% ( highest). Cycle-by-Cycle Over Current Protection.

Power max- 45W. Fitted with a UK 3-Pin Main Plug.

Output Power: Maximum power is about 300W. Output Current: 12A. High output current, the max output current can reach 12A. 1 x DC Buck Converter Module. Four high frequency capacitance can lower output ripple, enhance the work stabilization.

Capable of driving a 3A load with excellent line and load regulation. Output Current : Rate Current 3A(MAX). Module Properties : Non-isolated step-down module (buck). Output Ripple : less than 30mV. Get In Touch.

Output Power: The maximum power is about 300W. Output Current: up to 9A. Double heat sink design, MOS tube Schottky diode independent heat sink, good heat dissipation. Constant Current Accuracy and Temperature: In actual test, the temperature on the module changes from 25 degrees to 60 degrees, and the constant current value changes less than 5% (constant current value 5A).

The maximum load power is 100W. you need to check the switchs' place at the bottom of the adapter as follows 1 x UK Adapter. If you are not use it pls plug it out! - Very portable and convenient to use.