I full recommended this printer. After easy assembly it’s ready to used. It’s very important to be sure that all parts are perfectly folded and X line must be ideally levelled in relation to bed ( the best way to do this is when you take two paper sheets a4 ) . The Temperature PLA I set for 200 digress, bed 65 digress and printing speed 85 and that give me good printing quality. The step motor is very quiet and you can hear just vents cooling but not very loud. I attached here photos with my first 3d printing.
Verified purchase: Yes | Condition: New
The enders 3 v2 is made out of good extruded aluminium And has a nice control unit Bad points. The horrible bowden setup needs to be replaced with a direct drive to get rid of all the extruding problem The bed spring causes unreliability of bed leveling even with a BLTouch srnsor Needs an extra z stepper motor as the extruder gantry does not stay level Only buy this if your willing to spen £200 mor on it to make good. Other wise you will spen all your time trying to get good prints instead of enjoying 3D printing
Verified purchase: Yes | Condition: New
Goodsolid starter printer. I'm new to 3d printing and had this up and running in about 1 hour. The first couple of prints were ok but not perfect, then someone told me to change stock bed springs for upgraded ones. Total cost of these was £3.99 and it took me 5 mins to install, but it has turned a great printer into a excellent printer. Around easy to set up and use printer with good results, I'm impressed for the price range.
Verified purchase: Yes | Condition: New
Excellent product good quality easy to set up prints perfectly easy to put in stl files using included micro sd card and use adaptor amazing
Verified purchase: Yes | Condition: New
I found the included assembly instructions absolutely useless but after watching a YouTube tutorial I was printing in 30 minutes. I never tried any of the included models. The included filament was very nice. The printer hasn't needed any calibration out of box other than bed levelling and is producing very nice prints. Since I've bought it I haven't cleaned the glass bed but have been careful never to touch it with my skin and I've not had a failed print yet due to adhesion printing with PLA; printing with rafts makes it so easy to remove prints without waiting for cooldown, I just slip the spatula under and am straight to printing the next part. The fans on the printer are audible compared to rest of the moving parts, I would compare the noise to an old laptop.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in 3D Printers