|Listed in category:
This item is out of stock.
Have one to sell?

Creality V4.2.7 Motherboard FOR PARTS | NOT WORKING

ask_shop
(397)
Registered as a private seller
Consumer protection regulations resulting from EU consumer law are therefore not applicable. eBay buyer protection still applies to most purchases.
C $12.99
Approximately£7.08
Condition:
For parts or not working
Postage:
C $22.06 (approx £12.02) Canada Post Expedited Parcel - USA.
Located in: Barrie, Canada
Delivery:
Estimated between Mon, 4 Aug and Fri, 8 Aug to 94104
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the delivery service selected, the seller's delivery history and other factors. Delivery times may vary, especially during peak periods.
Returns:
No returns accepted.
Payments:
    Diners Club

Shop with confidence

eBay Money Back Guarantee
Get the item you ordered or your money back. Learn moreeBay Money Back Guarantee - opens new window or tab
Seller assumes all responsibility for this listing.
eBay item number:166067387988
Last updated on 02 Jul, 2025 18:22:42 BSTView all revisionsView all revisions

Item specifics

Condition
For parts or not working: An item that does not function as intended or is not fully operational. ...
Brand
Creality
Type
Motherboard
Compatible Model
Ender

Item description from the seller

About this seller

ask_shop

100% positive Feedback954 items sold

Joined Mar 2013
Usually responds within 24 hours
Registered as a private sellerThereby, consumer rights stemming from EU consumer protection law do not apply. eBay buyer protection still applies to most purchases.

Detailed seller ratings

Average for the last 12 months
Accurate description
5.0
Reasonable postage cost
4.9
Delivery time
5.0
Communication
5.0

Seller Feedback (215)

All ratings
Positive
Neutral
Negative
    • t***s (604)- Feedback left by buyer.
      Past 6 months
      Verified purchase
      Arrived on time and well packaged. Item as described with the exception that the board I received had the power connect terminal removed despite the board picture on listing had one. So, I soldered one in , flashed an updated firmware and installed it in a printer and it's printing a "Benchy" as I type. All good!
    See all Feedback