Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in RC Tools & Sets
This is a high quality tool for aeromodellers. It will allow you to make undersize propeller holes larger to fit your engine shaft perfectly. This tool is for metric shafts. There is also a similar tool available for imperial sized engine shafts. The cutting edges are sharp so watch your fingers. Keep the cutting edges protected when the tool is not in use - then it will last for a very long time.
Verified purchase: Yes | Condition: New
Does not work at all reaming APC propellers. After 10 minutes of hard work, I had managed to remove 1 mm plastic. Going in the bin.
Verified purchase: Yes | Condition: New
If you’re purchasing this for rc aircraft propellers, DONT, because it’s not fit for purpose, the 10mm ream is actually 10.26mm so you’re propeller will never sit true on the engine crank shaft therefore it’ll be out of balance. You’ll get no response from supplier,
Verified purchase: Yes | Condition: New
Seems ok on small diameters, 10 mm doesn't seem very sharp.
Verified purchase: Yes | Condition: New
Very useful for reaming propellers
Verified purchase: Yes | Condition: New