Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in 3D Printer Parts
This plate is an upgrade that all who use FDM 3D printers should do! This kit is complete ready to instal and makes adhesion problems a thing of the past! I’ve used one, for the last year on my Flsun I3 clone and it’s extremely rare for a print to fail because of it detaching or curling! Installing it is a breeze just insert screws, add the top plate and swap the lot. It even has the sensor plug on ready to swap over. The heater plate leads are preconfigured for 12volt, but can be used for24volt if required. In all it took less than an hour to switch out. And as I now have 3 I3 clones all now have this bed as standard. The other thing I’ve noticed is that using this build plate you seldom have to adjust for calibration I have during the lockdown printed some 200+ ear savers for the local front line workers and have not had to adjust calibration once! Just checked and it’s still dead on! I get a lot of use out of my printers so look forward to many many hours of trouble free printing! Thanks for reading.Read full review
Verified purchase: Yes | Condition: New
Good but for me it was to short as I didn't look at the size of it as I needed 220+240 not 220+220
Verified purchase: Yes | Condition: New
Easy to install, good quality, worked first time. Very good build surface.
Verified purchase: Yes | Condition: New
Works well, even temperature spread accross plate, good adhesion for prints
Verified purchase: Yes | Condition: New
Good bit of kit
Verified purchase: Yes | Condition: New