CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Amplifier Parts & Components
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
As a stereo power amp it is fantastic, however it not clear how to set it up in BTL mode because there are no detail of where the single speaker is connected or which input to use. A lot can go wrong if the ground connections are not correct, or the mono input signal is not split into phase and anti-phase
Verified purchase: Yes | Condition: New
Its ok but i would like tell me what kind of converter i should to buy for this amp. I would to buy if you recommend wich one is the appropiate. I buyed for home theater no for car. Thanks.
Verified purchase: Yes | Condition: New
Tested this out on a few different brands of speakers and it sounds good just running off 3.5 to rca from my phone. Hooked up to a power supply 36v 10amp, I got about 65 watts output into 8 ohms at full blast. Under 3/4 volume distortion isn't bad, but that last 1/4 gets horribly distorted.
Verified purchase: Yes | Condition: New
Installed the 4 jumpers for "Bridge Tied Load" monaural mode. Applied 36 VDC and an 8 Ohm load. Everything worked. There is, of course, some fuzz on the output but it is well above the audio range.
Verified purchase: Yes | Condition: New
Requires 36VDC@8AMPs or more (My application only requires a 15W output,so I only needed 5). So get a 356VDC power supply while you're at it. I had to build one, but they have them on ebay cheap. This little amp sounds CHOICE though. Zero hiss. Get good 8 ohm speakers, and it'll blow your mind.
Verified purchase: Yes | Condition: New
