|Listed in category:
Have one to sell?

12mm Hex Wheel Adapter Kit Vintage Team Associated RC10 RC10T RC10GT - 100-0066

Ideatech Products
  • (634)
  • Registered as a private seller
    Consumer protection regulations resulting from EU consumer law are therefore not applicable. eBay buyer protection still applies to most purchases.
US $15.99
Approximately£12.58
Condition:
New
More than 10 available / 503 sold
This one's trending. 503 have already sold.
Postage:
US $4.50 (approx £3.54) Standard Delivery. See detailsfor postage
Located in: Trenton, Georgia, United States
Delivery:
Estimated between Fri, 14 Jun and Mon, 17 Jun to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the delivery service selected, the seller's delivery history and other factors. Delivery times may vary, especially during peak periods.
Payments:
     

Shop with confidence

eBay Money Back Guarantee
Get the item you ordered or your money back. Learn moreeBay Money Back Guarantee - opens new window or tab
Seller assumes all responsibility for this listing.
eBay item number:294264008216
Last updated on 05 Jun, 2024 12:28:03 BSTView all revisionsView all revisions

Item specifics

Condition
New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging ...
Compatible Brand
For Team Associated
Brand
Team Associated
Type
Wheel
Custom Bundle
No
Compatible Vehicle Type
Cars, Trucks & Motorcycles
Model
RC10
MPN
100-0066
Compatible Scale
1:10

Item description from the seller

Ideatech Products

Ideatech Products

98.8% positive Feedback
1.3K items sold
Joined Aug 2001
Usually responds within 24 hours

Detailed seller ratings

Average for the last 12 months

Accurate description
5.0
Reasonable postage cost
4.8
Delivery time
5.0
Communication
5.0
Registered as a private seller
Thereby, consumer rights stemming from EU consumer protection law do not apply. eBay buyer protection still applies to most purchases.

Seller Feedback (457)

s***9 (69)- Feedback left by buyer.
Past year
Verified purchase
The kit worked well for a non-Factory Team RC10T3. Proline 2.8 12mm hex wheels will fit on the front if the small axle spacer is left out. For rear axles with dogbones instead of CVDs, leave the existing roll pin and washer in place and slide the hex adapter on (sort of a hybrid between assembly method "A" and "B"). The 3/32" roll pins in the kit will work as spares. Super simple!
3***0 (699)- Feedback left by buyer.
Past year
Verified purchase
Item as described. Fast shipping. Parts fit well, very little clean up. Thanks
_***m (626)- Feedback left by buyer.
Past 6 months
Verified purchase
On time shipping and in good condition.
See all Feedback