|Listed in category:
Have one to sell?

Cooler Master NR200 NR200P ATX PSU Power Supply Front Mounting Bracket MasterBox

Foggy Sea Super Finds
  • (2134)
  • Registered as a private seller
    Consumer protection regulations resulting from EU consumer law are therefore not applicable. eBay buyer protection still applies to most purchases.
US $24.99
Approximately£19.65
Condition:
New
Last one / 102 sold
This one's trending. 102 have already sold.
Postage:
Free Standard Delivery. See detailsfor postage
Located in: Stamford, Connecticut, United States
Delivery:
Estimated between Fri, 14 Jun and Mon, 17 Jun to 43230
Estimated delivery dates - opens in a new window or tab reflect seller's dispatch time, origin postcode, destination postcode and time of order receipt, and will depend on the delivery service selected and receipt of cleared paymentcleared payment - opens in a new window or tab. Delivery times may vary, especially during peak periods, and are an estimate only.
Payments:
     

Shop with confidence

eBay Money Back Guarantee
Get the item you ordered or your money back. Learn moreeBay Money Back Guarantee - opens new window or tab
Seller assumes all responsibility for this listing.
eBay item number:304110320208
Last updated on 09 May, 2024 15:59:43 BSTView all revisionsView all revisions

Item specifics

Condition
New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging ...
Brand
Cooler Master
Type
ATX PSU Bracket
MPN
nr200p
Country/Region of Manufacture
United States

Item description from the seller

Foggy Sea Super Finds

Foggy Sea Super Finds

99.6% positive Feedback
4.7K items sold
Joined Jul 2004
Usually responds within 24 hours

Detailed seller ratings

Average for the last 12 months

Accurate description
4.9
Reasonable postage cost
4.9
Delivery time
5.0
Communication
5.0
Registered as a private seller
Thereby, consumer rights stemming from EU consumer protection law do not apply. eBay buyer protection still applies to most purchases.

Seller Feedback (1,471)

g***a (728)- Feedback left by buyer.
Past year
Verified purchase
Item came packaged safely in a box with airbags. A bit difficult to install the lower 2 screws but it seems stable enough with just the two on top. Definitely better than just zipties to hold up an ATX PSU in the NR200. 3D print seems quite sturdy, but I do wish the PSU could sit flush at the end so it could be screwed in properly, sadly it isn't designed that way.
a***3 (12)- Feedback left by buyer.
Past year
Verified purchase
Fast shipping, nice piece. I'm using to mod old mico atx cases I had colleting dust I'm the basement.
e***l (402)- Feedback left by buyer.
More than a year ago
Verified purchase
I would actually rate it neutral or negative, item arrived cracked (it’s 3d printing so it’s brittle) and almost shattered during installation
See all Feedback