Power rails can be hard to locate exactly where they need to be. These clips are a good way to deliver to, or share power between, zones of track. You need to be able to slot them into a section of the track with a slight gap between rail and 'sleeper', so each terminal meets a rail. This is a bit fiddly, but once done they hold in place fairly well. They seem to work best when held firmly flat, so the power isn't disrupted when an engine goes over. These can be more easily disguised than a power rail, which helps keep thjngs authentic, or magical, depending on your perspective.
Verified purchase: Yes | Condition: New
The product works well and enables me to power branch lines and circuits not connected when points are changed. However I found the wire a bit on the short side and could have been longer as it is not always easy to line the track up close enough to link them.
Verified purchase: Yes | Condition: New
Purchased a Hornby original product in unopened Hornby packaging, complete with detailed instructions. Easy, smooth fit, linking two loops of Hornby track to one controller (early stages of building a layout with Grandson!! - keep it simple to begin with).
Verified purchase: Yes | Condition: New
Very good fitted as per the original
Verified purchase: Yes | Condition: New
Its 5 star because its a genuine product from Hornby being sold at a very fair price including postage. Good value and saved travelling 20 miles to the nearest stockist
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Track
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Track