CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in 3D Printer Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
These work great. They were plug and play in my Ancycubic Kossel Linear Plus. Helped to greatly reduce the noise of my machine and helped reduce vibration and ghosting, too. A few notes: - The solder did not take to these as easily as the name brand TMC2100's I have. Still works, just more challenging to solder. - The PCB is a little long. In order to get these to fit on my board I had to take a file and file down each end so they would fit one after the other.
Verified purchase: Yes | Condition: New
This reasonably priced SilentStepStick board has an awesome oversized via pad for improved heat transfer. Seems to work great in my tests. Several of the other options on ebay have solder mask over the transfer vias, rendering them useless. Additionally the pads and headers are gold plated. A nice touch that I usually don't see for this price. Best of all, it uses the 2208 version of the TMC driver chip, which is configurable via UART (see the SilentStepStick GitHub page for an easy to use utility) instead of having to fiddle with tiny solder bridges. The TMC drivers themselves seem to be worthy of the hype. Homing is so silent I have to look at the printer to notice things are moving. Highly recommended!
Verified purchase: Yes | Condition: New
I bought these for my AnyCubic Kossel Plus and just swapped out the stock drivers. The configuration needed to have the direction lines inverted, but other than that it was a straight swap. The difference is amazing. These drivers make the motors so much quieter. Just the quiet alone is worth the cost. I haven't experimented with printing faster yet or any other features of the drivers. Construction of these appeared to be good and clean. I just had to solder on the headers and stick on the heatsink.
Verified purchase: Yes | Condition: New
Very easy install. Just solder the pins, attach the heatsink, install the driver and invert the axis. Then you are good to go. Major improvement over the 4988 drivers. These make almost no sound at all.
Verified purchase: Yes | Condition: New
These drivers are absolutely awesome! I only soldered connections and lowered voltage, now I can hardly hear my 3D printer, I highly recommend!
Verified purchase: Yes | Condition: New
