Picture 1 of 8
![Picture 1 of 8](https://i.ebayimg.com/thumbs/images/g/HrAAAOSwiJBhH59h/s-l500.jpg)
![Picture 2 of 8](https://i.ebayimg.com/images/g/IjcAAOSwks9hH59i/s-l64.jpg)
![Picture 3 of 8](https://i.ebayimg.com/images/g/gSwAAOSwfz1hH59k/s-l64.jpg)
![Picture 4 of 8](https://i.ebayimg.com/images/g/ifQAAOSwX9BhH59m/s-l64.jpg)
![Picture 5 of 8](https://i.ebayimg.com/images/g/5SgAAOSwUSFhH59n/s-l64.jpg)
![Picture 6 of 8](https://i.ebayimg.com/images/g/rooAAOSwFPZhH59q/s-l64.jpg)
![Picture 7 of 8](https://i.ebayimg.com/images/g/f-kAAOSwW4lhH59r/s-l64.jpg)
![Picture 8 of 8](https://i.ebayimg.com/images/g/xFQAAOSwySdhH59u/s-l64.jpg)
Picture 1 of 8
![Picture 1 of 8](https://i.ebayimg.com/images/g/HrAAAOSwiJBhH59h/s-l1600.jpg)
![Picture 2 of 8](https://i.ebayimg.com/images/g/IjcAAOSwks9hH59i/s-l1600.jpg)
![Picture 3 of 8](https://i.ebayimg.com/images/g/gSwAAOSwfz1hH59k/s-l1600.jpg)
![Picture 4 of 8](https://i.ebayimg.com/images/g/ifQAAOSwX9BhH59m/s-l1600.jpg)
![Picture 5 of 8](https://i.ebayimg.com/images/g/5SgAAOSwUSFhH59n/s-l1600.jpg)
![Picture 6 of 8](https://i.ebayimg.com/images/g/rooAAOSwFPZhH59q/s-l1600.jpg)
![Picture 7 of 8](https://i.ebayimg.com/images/g/f-kAAOSwW4lhH59r/s-l1600.jpg)
![Picture 8 of 8](https://i.ebayimg.com/images/g/xFQAAOSwySdhH59u/s-l1600.jpg)
I Bought some Philips Ultinon LED W5W side light bulbs to go in my Audi, which are better than the standard side light bulbs, but after a little while threw up a bulb out error warning on the dash. So I got some of these Philips Canbus Resistors to stop the error message, I have marked them as good value, and to be honest at £12.49 they are not badly priced, wouldn't want to pay any more than that, to be honest. They are an easy fit just needing a pair of pliers to squeeze the Scotch locks closed, easy D.I.Y job if you are mechanically minded, because I had to remove both headlight units to fit these, whole job took about 45 minutes. Although a bit of a tight squeeze, they were easy enough to fit inside the headlamp unit, so they would be water proofed and mount using the sticky pads supplied. Tried the lights and miraculously no more bulb out errors, although not particularly cheap the Philips resistors I would say are way easier to fit than having to start messing about with cutting wires and soldering, using any cheaper alternatives that might be available. I would completely recommend these if you have Canbus and you get errors after fitting LED side light bulbs.Read full review
Verified purchase: Yes | Condition: New
2 pack but One of the canceller is not working as should I measured the resistance and different is 0.04 ohms and bulb error code occured
Verified purchase: Yes | Condition: New
Both units in the twin pack didn't work. Buy the cheaper non branded stuff cos it works.
Verified purchase: Yes | Condition: New
Excellent item, easy to fit, works a treat,
Verified purchase: Yes | Condition: New
Not good for my led break lights because they are 21/5w
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Light Bulbs & LEDs
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Light Bulbs & LEDs