Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Frame Rails & Subframes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Frame Rails & Subframes
Used to install new rubber bushes on mk5 fiesta. Didn't need to use for removal of old bushes as drilled into rubber so cut through outer nylon/plastic coating so could then tap out with a hammer. Installing new bushes was easy with the tool but need to make sure it is pulling bush into axle straight. Don't need to use a massive amount of force if they are going in straight and you are using tool correctly. Before using tool make sure you have cleaned and greased the new bush as well as the hole you are fitting it in. Also grease the threads and nuts and washers of the tool. If you're finding it difficult to do you may be doing it wrong.
Verified purchase: Yes | Condition: New
Made replacing 2005 fiesta bushes easy. Removal tool especially useful, came out easily. The new ones go in easier than they come out. Make sure to line up new bushes very carefully. Start to finish changing original bushes (17 years old) 2 hours. Re aligning the rear axel would have been much easier with a trolley jack & and 2nd person!
Verified purchase: Yes | Condition: New
Worked as intended to change the rear axle bushes on a mk6 fiesta ST, using Febi Bilstein plastic bushes, well made product
Verified purchase: Yes | Condition: New
Easy to use cuts down repair time Only use with genuine plastic bushes
Verified purchase: Yes | Condition: New
Perfect for my job and thanks.
Verified purchase: Yes | Condition: Pre-owned