 |
A genuine Hotpoint spare part. Relatively easy to fit with just a screwdriver (typically Pozi #2) for two screws. The hardest part is reaching at arm’s length to pull off the connectors from the old element, they can be a bit tight. Maybe careful use of pliers is a good idea to safeguard against hurting fingers! Once the old one is removed, installation is easy and takes just minutes. Take a note of the orientation (top and bottom) of the old element to ensure the new one goes in the right way and also check the guides (left and right) engage correctly in the slots of the oven wall. It’s a very straight forward DIY job.
Verified purchase: Yes | Condition: New
The grill element was easy to fit and works a treat, I shall be using this supplier again.
Verified purchase: Yes | Condition: New
The product is bang on, and so easy to replace 2screws inside six outside, four wires to disconnect, take out the old replace the new in the reverse order thanks a gain
Verified purchase: Yes | Condition: New
My original grill was stamped Hotpoint (Creda) This replacement was stamped Sarterm so not quite sure if this really is a genuine Hotpoint Grill Element. It did fit easy enough though :- I guess only time will tell if it buckles like the cheap ones do
Verified purchase: Yes | Condition: New
Genuine part at a good price. Easy to fit. Arrived in flimsy plastics bag which meant that 3 of the 4 connectors were slightly bent. Managed to bend back into place easily with pliers, but would be better if the connectors were protected with bubble wrap or similar
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Cooking Appliance Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Cooking Appliance Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
