This kit is probably the best one out there for air rifles. All the items inside are good quality. The instructions mention using a straw to get the pull through past a silencer, it would have been better if they had just added one to the kit. Also some some sort of small tool to help get the pull through tail out the magazine end of a PCP barrel would be great. This would cost very little but make the kit 5 star and unbeatable. Get a magnifying glass ready to read the instructions too, they are printed very small with black writing on a red background so not easy to see. These small improvements would really improve the kit.
Verified purchase: Yes | Condition: New
Almost impossible to use on an Air Arms .177 calibre S510TC. Feeds in through the moderator and into the barrel up to 28cms then stops dead, the heat shrink around the brass ferrule makes it too big if the nylon end loop ends up along side it. The only way I got this all the way to the breech aperture was to first feed in a thin wire to the breech, attach the other end to the nylon loop and physically pull the cable down the barrel to the breech aperture then fit cleaning patches x 2, pulling back up the barrel with patches was easy. Half a millimetre off the loop end diameter would make this easy to use.
Verified purchase: Yes | Condition: New
Here is everything you need in a nice packet from Napier. Their Pull Through Kit is just great in comparison to other cleaning options I have used before and is realy not harmful to your equipment like certain of those metal brushes are to the barrel. The Power Air gun oil is not only good for cleaning but also very good for lubricating those essential parts on your airgun. For me its the best solution and I use it both on my BSA R10 FAC and my Air Arms S510 U.S. Xtra FAC with exellent results.
Verified purchase: Yes | Condition: New
I have an Air Arms S510 .177. I couldn't get this into the barrel and thought it was just me not poking it in the right direction, After looking closely at the crimp holding the cord in place I discovered that the plastic covering the crimp was mis-shapen. I solved the problem by carefully cutting back the plastic by about 3/16ths of an inch with a craft knife blade. It's still a close fit but at least I can use it now.
Verified purchase: Yes | Condition: New
Its good and does what it says on the tin. For infrequent use, its not good value. The cleaning pads, VP90 Field patches. These are terrific and I'll be purchasing more, as only 3 supplied in this kit. If there were more VP90's included it would then be VFM.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Cleaning Supplies