CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Cabinets & Cupboards
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
These shelf brackets are the best solution I've seen so far for adding extra shelves to you Ikea Detolf cabinets! People have been using metal wire rope clips to add shelves to their Detolf's but these brackets are a superior solution to those. They are 3D printed from grey plastic and are pretty sturdy little brackets. The grey color goes with the grey powder coated shelf frames in Detolf cabinets much better than the metal wire rope clips. They also support shelves better as they extend farther under the shelves. Wire rope clips just barely catch the edge so these plastic brackets are a better and safer supporting bracket.
Verified purchase: Yes | Condition: New
Unfortunately the Nuts didnt fit the slots making this very fiddly., The actual clips slots were a little bigger to secure the nut when the bolt inserted needed to be tighten As this was making the nuit spin when the bolt is inserted, I had to secure the nut myself, and this was making theses very very fiddly in a glass cabinet. The material when tightened burnt white making it weaker around the 5mm bar, as this was the grip I needed to secure it tightly without it slipping down. On the plus it's held a 1lb weight and I wouldn't really trust theses for anything heavier.
Verified purchase: Yes | Condition: New
These work quite well and are relatively easy to install. Being plastic they tend to negate the need for a soft rubber layer for the shelves to rest on (as is the case with the metal structure that the standard shelves rest on). If I had a small gripe it's that the nut sometimes spins in the socket as you tighten the bolt. I sometimes had to use vice grips to grip the nut as I tightened the bolt. If the socket was a little tighter the nut wouldn't be able to spin. Otherwise, a great product. Would recommend.
Verified purchase: Yes | Condition: New
I lucked out and heard about these on a figure Collection site and must say they are perfect. Super easy to install and great quality. The only problem with my detolfs has always been that you can’t adjust the shelves and this solves it. Perfect.
Verified purchase: Yes | Condition: New
it is 3D printed, and that is cleary visible by close look. but if you dont check it from close then it is OK and I use it for detolf case and it can hold dditional glass shelfs plus 2-3kg of weight. So from my point of view it works and it is good option to use if you need additional shlefs to your showcase.
Verified purchase: Yes | Condition: New
