 |
Very Good product - Fitting was simple and the silicone grease was handy to prevent the o ring being damaged. Getting the original turbine out was a lot more difficult however !
Verified purchase: Yes | Condition: New
I fitted one today fortunately it was ground floor flat, as after fitting two hours later I was called back as water was coming from boiler the was water leaking from the turbine I fitted the other one and that leaked worse, I found the o-ring on the turbine was too small and was not sealing causing mains water to leak all over the cupboard I had to spend the next 2hours drying out the boiler and kitchen cupboard. not impressed
Verified purchase: Yes | Condition: New
It works as it should it is a redesigned type compared to the original but just remove one cartridge and fit new one
Verified purchase: Yes | Condition: New
It works - Hot water again from the boiler. First try replacing the sesnor that fits on the top of this unit as there is not that much to go wrong in the catridge unless the turbine is actually jammed. it may not be required and is a little expensive for what it is. May be difficult to remove the old cartridge due to corrosion.
Verified purchase: Yes | Condition: New
This product is such good value for money and saves so much time since you only have to isolate the mains water side to complete the repair.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Standard Water Heaters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Standard Water Heaters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
