Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Cars & Motorcycles
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Cars & Motorcycles
This was easy to install on my E-Revo 2.0. I removed the motor, put the mounting plate on and then screwed the heat sink into it. Make sure to leave the heat sink lose so you can position it once the motor is installed. Great product that keeps my motor cool. I wasn't having overheating issues, but I decided to install it preemptively as a maintenance item.
Verified purchase: Yes | Condition: New
Great fan setup. It has reduced temperature by about 20 degrees celcius on my motor. This is critical as it was runninng way too hot on 6S batteries (around 90 + degrees) and now runs at 70 degrees approximately. I had to modify the mount slightly to fit in my Tekno but other than that it works great and was easy to install. I used a y splitter cable to plug both fans into the receiver which works perfectly.
Verified purchase: Yes | Condition: New
Great heatsink/fan setup. This is my second one, Have one on my Arrma Senton and now my Kraton. Drops motor temp dramatically around 40f. Allows you to gear higher for more speed. Fans move a lot of air, and heatsink fits tight. Great product.
Verified purchase: Yes | Condition: New
Got this for my kraton to keep motor temps down while bashing with my 6500mah 6s batteries. I use the high speed pinion and the motor was getting to hot. I bash pretty hard and this has held up so far. Just make sure you have an adapter wire cause the 2 connections in this do not plug into your receiver, you need a male JR to a female JST y harness to make this work.
Verified purchase: Yes | Condition: New
I want to say the difference between the heat of my motor before and after I put the heat sink and twin motors on was unbelievable!! I honestly did not think I would see such a huge difference but I absolutely did on 6s with my kraton V2 with a 16 tooth pinion my temps were out of control it is very hit where I live and my temps were getting into the 180-190° range this will kill a motor so I new I had to find a solution and now after installing this my temps are down to 120° on 6s and that was running full throttle the whole time I just can't believe the difference that is over 60° !!!! My motor is running so cool you can at any point put your hand directly into the motor and hold it there without it being to hot ! I will be getting one of these for each of my rigs I will never have to worry about temps again!! So happy I can not recommend this product enough!!Read full review
Verified purchase: Yes | Condition: New