 |
Bought for use on my boat to secure lagging round the exhausts and as strapping round a cracked wood burner for extra support. Have used similar before. Found it easy to cut and after a bit of trial and error finding the best way of securing the tail end, easy to use. On tightening it helped if you gripped the worm drive unit with a pair of water pump pliers and with this method I was able to get enough tension to achieve a “ping” when flicked with a finger nail. As this is cheaper and far better than some I’ve tried before, I’ll be buying this again as it’s always handy for the many different size hoses on a boat. I also tried it on a cooling hose of 2 inch diameter and it tightened fine with no slipping. So yeah, brilliant! Thanks.
Verified purchase: Yes | Condition: New
These are great and easy to use if you need a non critical join as they are easy to measure up, cut and make your own size. However the band material is very soft so if you tighten the screw too much the band simply tears and the clip does not hold. The original jubilee could be tightened up a lot more as its band material was much tougher. I used these on the diesel exhaust of my small sail boat where there is no pressure. The first one tore on tightening up so another was needed. They did work though. although I wouldn't trust these on water inlet pipes or oil pressure pipes etc. Still pleased I bought the kit as they have many uses.
Verified purchase: Yes | Condition: New
Had to replace some pipe clamps missing from a jet ski exhaust . This kit did the job , but they are a bit thinner than the originals , and are easy to over tighten which then bends the threaded slots on the band and goes loose like when the thread on a nut and bolt are stripped . Cheap solution to fix the problem , not sure how long they will last ?
Verified purchase: No
This kit is not fit for purpose. On first opening it looks very good but when I tried to use it I found that looks can be deceiving. The qualityleaves a lot to be desired and the clips you can make are useless. This was a waste of money.
Verified purchase: Yes | Condition: New
This product gives great versatility to the user. Clamps of any size can be made up. With this kit up to 8 clamps can be made.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Hose & Cable Clamps
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Hose & Cable Clamps
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
