Picture 1 of 1
Stock photo
Picture 1 of 1
Stock photo
Cougar Wide Ramp 2500kg 2.5 Tonne Pair Capacity Car Van Vehicle Accessory
Thompsons Ltd (183036)
99.9% positive Feedback
Price:
£44.95
Returns:
60 days return. Buyer pays for return postage. If you use an eBay delivery label, it will be deducted from your refund amount.
Condition:
2.5 Tonne total load capacity. Cougar Car Ramp X2. 210mm wide 250mm high and 800mm long (vehicle wheel raised 200mm Approx). 255mm wide at base 210mm platform width 250mm high and 800mm long (vehicle wheel raised 200mm).
- Buy it nowCougar CRW25 2.5 Tonne Wide Car Maintenance Lifting Equipment Ramps Pair
Oops! Looks like we're having trouble connecting to our server.
Refresh your browser window to try again.
About this product
Product Information
These heavy-duty car ramps have a combined capacity of 2.5 tonnes and are extra wide to allow for vehicles with wider wheels, while their design is compatible with Ramp Mate car ramp extensions to allow for access for cars with lower ground clearance. An essential automobile accessory that will perform well for years to come.Product Identifiers
BrandCougar
MPNCRW25
Manufacturer Part NumberNOT FOUND
UPC0689989152278, 5013569200021
eBay Product ID (ePID)1305554815
Product Key Features
Vehicle TypeHeavy Duty/Commercial
Capacity (Tonne)2.5
FeaturesHeavy Duty
MaterialSteel
TypeRamp
Dimensions
Weight9.86kg
Height80cm
Width24cm
Length250 mm
All listings for this product
Ratings and reviews
Most relevant reviews
- 19 Aug, 2022Most favourable review
Heavy duty
Supported my vehicle as it should. Not a fault but I would have thought welding the vermicelli supports would be better on the inside of the angle iron than the outer. In the event of a weld failure the upright would rest on the base rather than lose all its strength. I will keep an eye on it. If it was being used a lot I might return it.Verified purchase: YesCondition: New
- 17 Apr, 2019Most critical review
You get what you pay for.
Straight to the point; I wouldn’t trust these ramps with 2.5t on them! Before I worked under my 4x4 (2.3t), I made sure I used good quality wheel chicks and axle stands. The angle-iron is too smaller a gauge to be ‘heavy duty’, the welding is very ‘blobby’ and ‘unfinished’, almost as if it’s just tacked together and yet to be welded properly. Extra wide? I’d hate to see the standard sized ones then! My Jeep with standard tyres on hand over both sides of the ramp. You have to be very accurate and very careful when putting your vehicle on them. Beware the random sharp edges: use decent work gloves to grab these ramps or you will draw blood. Numerous times. Don’t ask me how I know this .......... As a positive, they were very cheap compared to the competition. Because they are very ‘cheap’ .......... It’s difficult for me to recommend these.Verified purchase: YesCondition: New
- 20 Aug, 2020
OK for small light vehicles
The packaging for this product was all but useless, a fairly heavy item in a flimsy large cardboard box is not going to work. Items were not damaged luckily, but must have been very awkward for the carrier to deliver. Product works OK , but quality isn`t great, welds are messy and some very sharp edges, which I buffed down with a file. Ramps are not very wide, anything over 185 tyre size will likely overhang, and the ramps tend to slip easily when driving up on to them. I used some old railway sleepers under them to get a bit of grip which worked out OK, this also increased the height clearance, other wise it would be a bit of a squeeze to get under the car, even if small build. I would only use these for small cars, they may be suitable for bigger vehicles, but I am not convinced. Also NO instructions or tips on safety with these at all, which I feel is essential, I have used ramps before, so I know how to be careful, but others may not.Verified purchase: YesCondition: New
- 08 Jun, 2020
Great value and does the job
These work fine for me, could be better. I had to use a high lift jack to get my car onto them its too low to drive up but that would be the case for all ramps. If I had any recommendations it would be that they are a little narrow for today’s tyres - mine overlap both side, and also that the part the tyre rests in is very short for large diameter wheels - you only just get to top of ramp before hitting the stop. Finally the steel is quite thin gauge - nothing like the old ones used to be, so only for small cars. Think a Range Rover or similar would crush them flat so check you cars weight before getting under them. I couldn’t find anything better for sale !Verified purchase: YesCondition: New
- 06 Jun, 2017
Should have looked at reviews first.
After I placed and paid for these, I checked other reviews and found a mixed bag. I thought some people were just being a bit harsh regarding quality and finish. First hand experience is always best I thought. The units arrived fast, and im not surprised, as mine arrived with areas of rust already on a few areas. They appear strong, but the welds are badly done, and so is the finish. My Vectra is 1550 in weight, so at 2 and half tons rating, they should be safe. But i'll drive up these with caution. If I hear the slightest creak, i'll be dumping them and buying something better. I'm the one who will be underneath the car working. Before I use them though, i'll be sanding off all the sharp edges of the welds (some are razor sharp) and giving them a good coat of hammerite or I doubt they wont survive the elements. I'm not surprised some have considered sending theirs to trading standards as they do seem a bit of a bodge job. I wonder if the seller has taken these points up with whoever makes these or in fact have actually used the ramps.Verified purchase: YesCondition: New
- 26 Aug, 2020
Good quality but with a design flaw
These ramps are of good quality and the extensions work well with low cars - such as my Ford Focus, BUT they are unstable and for this reason I am wary of recommending them. The front edge (below the stop bar) is vertical; when I drove up them and the tyres met the stop bar the ramps tipped up - the ramp end jamming under the sill. I had to back off a bit to bring them back to the ground. I have other ramps, on those the base extends further forward than the top and the stop bar, meaning they don't tip. These could be good but need a design modification - the front should slope forward to a longer base. Use with care.Verified purchase: YesCondition: New
- 08 Aug, 2018
Better than i expected, mine are Strong, Sturdy and safe to use, great item for the price, perfect for use on my 4x4.
After reading several reviews of this item on various sites i was hesitant whether to purchase or not, but i took the plunge and got them, i am pleased i did, they are fantastic, good quality for the price, strong and do the job, i have a 4x4 (Landrover) and they are fine for that.Verified purchase: YesCondition: New
- 08 Dec, 2018
Ok for price, but check size.
As others have said, build quality not the best with loads of weld splatter but for the price that is to be expected. I cannot see though how 21cm wide is classed as extra wide, to me that is misleading as most car ramps are around this width and they are not very tall. Overall though, price alone makes them worthwhile, particularly with free delivery.Verified purchase: YesCondition: New
- 05 May, 2021
Stout and good value
Looks sturdy and reasonably well made. I might put some more paint on them as they will spend most of their life outdoors. One star lost because none of my cars can drive onto the ramps due to to the steep angle. The bottom edge of the bumper apron fouls the ramp. This is not an insoluble problem but is a minor inconvenience.Verified purchase: YesCondition: New
- 03 Mar, 2021
Simple and safe to use.
just the right height, sturdy and well finished. Proved themselves this last week when I did the oil and filter swap on my 2 tonne shogun.Verified purchase: YesCondition: New
