 |
Decent size heel trips to prevent you wearing the heel edges of your shoes. Reasonably hard wearing. When gluing to your shoes use high viscosity super glue NOT the thinner type. Downside is on plastic souled shoes the glue eventually eats into the plastic and dissolves it but that is only after a while. Use a two part Araldite adhesive to fill the gap that has been dissolved in the shoe soul.
Verified purchase: Yes | Condition: New
Arrived quickly. Read below. Cut into rubber heel and trial and error until rubber replacement fits snuggly into slot cut into heel. Pride open cut and insert glue and then replacement. Apply pressure to get clue to set , be careful glue is not set as heel insert can move out. Leave for eight hours. No problem as heel height has been replaced and cannot come away from trainer
Verified purchase: Yes | Condition: New
The purchase of this kit was easy and speedily delivered. The application of the heels was good by following the instructions to the letter and the heels have stuck fast. I used a hair drier to warm the shoes and kit to make sure the shoes are dry and the glue nice and soft. My only reservation was that the heels are quite thin and I wonder how long they will last. OK so far. I would recommend this product to extend the life of your shoes.
Verified purchase: Yes | Condition: New
Wearing light ballet type shoes they don't last but with these heels stuck on......no problem, excellent. Will be reordering.
Verified purchase: Yes | Condition: New
The kit contains everything you need including good clear instructions. I've already put the new heels on my shoes and after the first outing they seem to be stuck fast.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Shoe Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Shoe Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
