 |
The guards themselves are stout and welded well, zinc plating is fine if not the most uniformly covered The issue is the bolts are made of cheese and not long enough to get the clamps started to pull in, also the heads are too small for the holes so washers are used and they start to deform and pull into the holes as you tighten them. Really the bolts needed to be stronger grade and longer to allow for having to open the clamp up to get them on. Buying new bolts solves this issue. Overall though cheap enough to be a variable issue until you get round to Maning up and welding on proper end caps😜😂
Verified purchase: Yes | Condition: New
My rear diff housing was damaged and repaired more time before i boughr my disco 1, the fluid was leaking continuously, i had to change the whole diff housing, compared to the prive of that this guard worth every penny, i wish the pre-owner installed it earlier...
Verified purchase: Yes | Condition: New
Very high quality materials with an excellent finish. I haven't installed them as yet but they look spot on.
Verified purchase: Yes | Condition: New
Theese diff guards are way too slim in materilal to hold up even a millder terrain once screwed in place.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Additional Differential Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Additional Differential Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
