Ideal for connecting two butts or for replacing a broken connector. There's not much to say about such a simple device .. it is what you see... but the quality is good and the seals work well. I would only highlight that the connector stubs and therefore the pipe are a slightly bigger diameter than others you might have (I have a Homebase water butt) which means the pipe is too big to fit over some other adaptors. If you're connecting two butts together you have to use the pack connector stubs at each end. If you're using the pipe to connect to a gutter, then you have to make sure your gutter piece has a big enough stub. The tube in this pack is 22-23mm in diameter.
Verified purchase: Yes | Condition: New
Not good, you need a T piece, to connect water butts together, as the water will flow from the full one into the empty one, also the actual hose size is much to big for the T piece on mine, as they are only 20mm, this was a waste of money for me! The actual hose & fittings are fine...
Verified purchase: Yes | Condition: New
It does what it is intended to do. Easy to fit but be careful when screwing locking washer on, it is easy to cross thread the plastic. The thread length on the spigot would be better if 10mm longer to make putting this locking washer on, especially if using on a 250L barrel. The linking corrugated pipe could also be longer, another 200mm would be useful but that is just "nit picking".
Verified purchase: Yes | Condition: New
This kit comes with all the pieces required to connect two water butts together. Easy to fit and appear to be good quality. Just check the length required between the water butts to make sure this is long enough. I've used two of these, doubling my water butt use from two to four without having to tap into the down pipes of the house twice.
Verified purchase: Yes | Condition: New
This is a useful bit of kit for linking up a series of water butts. The pipe is not very flexible and tends to remain in the curved position shown in the photograph. It is quite hard to push the pipe fully onto the connectors and I found that using washing up liquid eases it somewhat. Still once fitted it does a good job.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Water Butts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Water Butts